We found the following complaints for YAMAHA XV1900 (2006)
Read complaints for YAMAHA XV1900 (2006)
When i turned on the key my speedometer and other instruments cycles from zero to maximum back to zero one time.periodically, one of my indicators (usually the speedometer) does not cycle and then does not work during the vehicle operation.this has been going on for several years, but is becoming more frequent.i remove the instrument panel to check the wiring for shorts and did not readily detect any though i did notice the wiring harness is very tight just in front of the fuel tank -- i'm sure vibration from vehicle operation puts stress on those connectors.note:in conjunction with the above i have noticed periodic flickering of my instrument lights and headlight -- i am concerned one of these days my headlight will go out while i'm driving at night.it happened to me on a previous yamaha roadstar and that was a very frightening experience.
Coming off of highway to exit ramp coming to stop engine stalls.
Third gear is going bad
When i turned on the key my speedometer and other instruments cycles from zero to maximum back to zero one time.periodically, one of my indicators (usually the speedometer) does not cycle and then does not work during the vehicle operation.this has been going on for several years, but is becoming more frequent.i remove the instrument panel to check the wiring for shorts and did not readily detect any though i did notice the wiring harness is very tight just in front of the fuel tank -- i'm sure vibration from vehicle operation puts stress on those connectors.note:in conjunction with the above i have noticed periodic flickering of my instrument lights and headlight -- i am concerned one of these days my headlight will go out while i'm driving at night.it happened to me on a previous yamaha roadstar and that was a very frightening experience.
Almost died today.my bike stalled for the 17th time and as i stalled, i stopped hard because of the jolt of the stall and my bad back couldn't handle the weight being off balance so i had to lay the bike down.as i was falling to the ground, another car locked up her brakes to avoid killing me in the lane to the left.the bike routinely stalls when coming to a stop and i am hoping the yamaha corp will do the honorable thing and fix this before someone does get killed.i refuse to ride anymore and will not sell the death trap to anyone else.so, please recall and fix this problem as i really like my bike but not enough to die on it.it is unsafe to stall at all let alone randomly 4 out of 10 times when the bike gets hot.
Motorcycle just stops/ shuts off for no reason. Have stalled at red lights and on highway. Then very hard to start. Have spent thousands at dealer to fix, still not fixed.
3rd gear makes a lot of noise even in idle. People on line say it's a defective gear pin that yamaha knows about but won't recall.
The contact owns a 2006 yamaha xv1900a. The contact stated that while driving 30 mph and shifting to third gear, the vehicle began to shake and vibrate violently. The vehicle was taken to an independent mechanic for diagnosis and the contact was informed that the third gear would need to be replaced. The vehicle was not repaired. The failure and current mileage was 3,500.
I was riding home from college and i down shifted from 4th gear to third and heard a noise and the bike stalled. I was able to get it into neutral and it started back up again however if i shift into third it makes a horrible tapping noise. So, i have been riding the bike without using 3rd gear. I am a disabled veteran who lives on very little vet benefits which do not allow for me to pay for a top end rebuild which is required to change the gear. Nor can i pay for yamahas new third gear ( which is not the same part or part # that the bike was originally built with ) that they came up with to fix the problem.
Grinding/growling noise in third gear.
On march 21st of 2012, around 2pm, i left my house to head to work. When i approached the stop light (red) right off mckinley bridge on missouri side, i down shifted from 4th to 3rd gear when i noticed the bike lunged forward a bit and started making a grinding noise. The noise sounds like the belt is not grabbing onto the sprocket or something like that. I was told that there is alot of roadliner's and stratoliners xv1900's has this problem. The problem is with the 3rd gear pinion p/n 1d7-17131-01-00. Yamaha knows about this problem with the model bike in question but has not had a recall on this part yet. I was told that this problem could cause a catastrophic crash from the transmission locking up at high speeds. The replacement part has a new p/n (99999-03864.00).
Read more
