Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE
Use this form now and GET 20% DISCOUNT for CarVertical reports!




We found the following complaints for POLARIS SLINGSHOT (2018)

Read complaints for POLARIS SLINGSHOT (2018)


The contact owns a 2018 polaris slingshot. The contact received a recall notice for nhtsa campaign number: 19v750000 (electrical system). The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The contact called ridenow powersports peoria & indian motorcycle peoria (8546 w ludlow dr, suite 100, peoria, az 85381, (877) 822-1352) and was informed that the parts were on backorder until december 5, 2019. The manufacturer was contacted and provided case number: c/6129161t0c1h6. No further assistance was provided. The contact had not experienced a failure. The vin was invalid.

The contact owns a 2018 polaris slingshot. The contact received notification of nhtsa campaign number: 19v750000 (electrical system) however, the part to do the recall repair was unavailable. The contact called freedom powersports weatherford (3202 east interstate highway 20, hudson oaks, tx 76087; (817)241-2031) where it was confirmed that the part was not yet available. The contact was also informed that parts would be available between august-september 2020. Until then, it was recommended that the motorcycle not be driven. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

The vehicle was being personally inspected while stationary. I have noticed a significant wear difference in the right front brake rotor while it is being bedded. Upon closer inspection, i have determined that there are 2 different front rotor types on this vehicle. The right rotor is a single piece rotor while the left rotor is the dual-piece rotor that is supposed to be on the slr version. According to the manual, the single rotor minimum thickness is front 4.5mm, rear 6.5mm while the dual-rotor minimum thickness is front 19mm, rear 19m. They are significantly different sizes which will possibly cause adverse braking action and possible loss of control of the vehicle.




Read more




© 2024 All rights reserved