Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE
Use this form now and GET 20% DISCOUNT for CarVertical reports!




We found the following complaints for PLYMOUTH SUNDANCE (1994)

Read complaints for PLYMOUTH SUNDANCE (1994)


Consumer was involved in a 20 mph frontal collision in which the driver's air bag deployed.please give any further details.

Driver not a comfortable distance from steering wheel; awaiting legislation to allow air bag to be disconnected.

When airbag deployed it burned the occupant from the chin down. Please describe.tt

Consumer was involved in20 mph rear end collision in which the driver's air bag deployed.please give any further details. 826514 dup 0f 825398; posted on 09-07-1999.

When airbag deployed it burned the occupant from the chin down. Please describe.tt

The consumer had an accident on 020296 and the air bag didn't deply.please describe.tt

Vehicle was knocked into bridge wall, air bag did not deploy.tt

The rear window light bulb melts constantly and the dealer was unable to determine the cause of the failure.please provide further details.

Vehicleshut off, and will not restart while driving. Dealership has unplugged and replugged the computer chip, ran a diagnostic test, and checked the sensors, every thing was okay. A month laterand on 3 separate occasions the failure recurred.

Car started burning, pouring smoke into the car from every vent and opening possible, back left window panel actually melted from the inside, possible due to ashes getting between the window panels.

Thereis reoccurring smoke and fires coming from the rear of the vehicle near the speakers. The fires has happened twice due to electrical wiring. Dealer has seen vehicle.

Coolant sensor voltage shorted out, causing vehicle to stall.*skd

Boughtcar 2/15/98.dealer never corrected engine problems, but continued to replace different parts and charged full price

Engine replaced due to excessive oil consumption, vehicle displaying symptoms for 2nd time.

Auto caught on fire inside the paneling, no injuries.

The cruise control stopped the car slowed down and the engine caught on fire . Dealer has not seen.

Fuel vapor is leaking into the passenger compartment.the dealer will be contacted.

Fuel injectors replaced. *sd

Strong gas odor noticed and a puddle of gas was found under vehicle. A pinhole leak was found in fuel tank.

Had filled vehicle with fuel. It started to spill out of input pipe. Fuel gauge failed to register correct amount of fuel. Problem was repaired in august 1999. Indication was sensor unit was not in operation, but was intact.

Had filled vehicle with fuel. It started to spill out of input pipe. Fuel gauge failed to register correct amount of fuel. Problem was repaired in august 1999. Indication was sensor unit was not in operation, but was intact.

Vehicle fuel gauge will not register the right amount of fuel, in for repair put a sensor.tt

Vehicle was parked, emergency brakes on, unoccupied approximately 3 minutes, emergency brakes released on their own, vehicle rolled backwards down incline, hit a tree, owner engaged brakes again after moving vehicle, brakes released again on their own.

While driving on the highway the vehicle shiftedfrom d drive into neutral without being touched.

Gear shift lever does not lock in drive position; can accidently hit with hand causing inadvertent shifting to reverse or other gears; could cause accident.tt

When parking on a hill, it is hard to release gear .tt

Vehicle's rear axle has cracked in the middle due to design from a sqaure to replace a round design.

While driving heard metal noise. Anytime vehicle shifts the noise is there. Mechanic felt up to the axle, and found that the rod that runs through the rear axle welding had broken apart. Body shop welded it together, and approximately two months later the bar had broken again.

Vehicle's rear axle has cracked in the middle due to design from a sqaure to replace a round design.

My 94 plymouth sundance car has unsafe car seat belts (can come undone when bumped by an elbow, hand, or another child's car seat installed next to it).i am contacting my local dealer to make an complaint and ask for a replacement togen4 design seatbelts.as a parent, why would you install unsafe seatbelts? why isn't there an immediate recall? *la

Owner's daughter's finger was caught in the passenger's side automatic seatbelt retractor, and mangled her finger.manufacturer said that that it had nothing to do withthe design of the vehicle.

While putting the seat belt through css & trying to lock it, seat belt buckle failed to latch properly; the entire inside of the buckle just fell out of mechanism.was under investigation (pe #96008).

The shoulder part of the passenger's side seat belt does not retract.

When moving seat to a different position it is very hard to adjust. Also,once while driving the entire seat went back.1p3ap28d9rn.

Reporting a recall failure; after dealer replacing seatback bolt consumer noticed seat would fall forward freely. Dealer notified and informed consumer that was normal. Can nhtsa provide additional information or help in this matter. Checked my owner manual and learned that was not normal, and would like to know whydealer isrefusing to correct the problem correctly.

While getting into the vehicle one of the bolts that support the drivers seatback broke and caused seat to fall back,the seat will not stay in the up position,. Will be taken to dealer.

Recall 99v212 completed but consumer still has problems with seats flipping forward.

Recall repair (99v212000) could not be done due to distance / location of dealer.

The vehicle experienced the same problem as stated in recall # 99 v 212 000, however the vehicle identification number was not included in the recall.*scc

The front seatbacks failed to remain locked in place. Would recline forward, pushing driver/passenger towardssteering wheel/dashboard. Took vehicle to dealer , and mechanic refused to look at passenger's seatback.driver's seatbackwas under recall and would repair it. The failure of front seat back was due to poor design.

Vehicle sways/fishtails when applying brakes, causing accident.(other vehicle on 482740)*skd

Abs brakes;while driving brakes failed, causing the vehicle to run into another vehicle.please describe.

Abs brakes;while driving brakes failed, causing the vehicle to run into another vehicle.please describe.

Vehicle was parked, emergency brakes on, unoccupied approximately 3 minutes, emergency brakes released on their own, vehicle rolled backwards down incline, hit a tree, owner engaged brakes again after moving vehicle, brakes released again on their own.

Brakes very spongy-brakes do not hold.tt

When applying brakes in cold weather, there is an extended stopping distance before vehicle comes to a complete stop.please provide further details.

Vehicle fishtailed/swayed when applying brakes, causing loss of control/accident.(other vehicle on 479668).*skd

Steering column lower part is making a noise. Also,when trying to start the vehicle the key won't turn to start the vehicle.consumer stated that the dealer said that they needed a whole new steering column.

Vehicles tie rod right arm knuckle broke and car completely rolled over.tt

Water leaks inside vehicle due to insufficient amount ofsealant around cowl.

Reporting both front doors are deattching from the hinges of a broken weld; dealer notified and informed that vehicle out of it warranty and any repairs would be at consumer cost. Please provide any further details:

Driver's side door hinge broke due to excessive wear.

While driving down highway hood came up-no injuries were able to get off to the side.tt

Since the paint is peeling off of the car and chrysler refuses to fix it, claiming the 3-foot bare area on the roof of my car is normal wear and tear, the body of the car will rust, rendering it a safety hazard both to myself and to other drivers on the road.

Track bar between rear wheels failed.

Clanging noise due to a defective track bar between the rear wheels.

Rear axle replaced.

Due to the rear trailing arm failure, the consumer had an accident.

Trailing arm failed while consumer was backing out of driveway causing a scraping and grinding noise. Nlm

Floor mat became entangled in the steering mechanism, causing partial loss of steering and brakes.

While driving engine check light come on at all times. Had taken vehicle to dealer, but it could not be fixed.please provide more information.

Vehicle accelerates out of control, resulting in accident.tt

The cruise control stopped the car slowed down and the engine caught on fire . Dealer has not seen.

Sudden acceleration, causing loss of control/accident. *sd

Consumer has been experiencing problems with windows. Something in the driver's side window broke, and the glass fel into the car.in addition , it's hard to roll the passenger's sidewindow up or down.the manufacturer has been contacted.

When rolling down the window on the driver's side and passenger's side,window will come off the track unless consumerholds onto the window or rolls down the window slowly. Problem was reported to the dealership.problem was corrected once.consumer still experiencing problem when rolling down the window.

Fire between the window panel and vehicle due to possible electrical failure.

Consumer has been experiencing problems with windows. Something in the driver's side window broke, and the glass fel into the car.in addition , it's hard to roll the passenger's sidewindow up or down.the manufacturer has been contacted.

Windows jam/bind.

Track bar betwwwn the rear wheels was the cause of the clanging noise, dealer said there was a recall, manufacture said recall did not relate to their vehicle.




Read more




© 2024 All rights reserved