Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE
Use this form now and GET 20% DISCOUNT for CarVertical reports!




We found the following complaints for OLDSMOBILE CUTLASS (1987)

Read complaints for OLDSMOBILE CUTLASS (1987)


Engine mounts failed.

At 30,000 miles vehicle needs a new engine.ttconsumer states steering rackwas replaced.

Engine failure causing fire.ohio state police report.

Vehicle was parked for a few minutes, then caught on fire from under the front grill of the vehicle.

Engine compartment fire, causing fatality.(attorney for client)

Muffler failed.

Oxygen sensor failed.

Transmission failed to shift into reverse.

While driving at approximately 25 mph lost control of the vehicle due torear axle disconnecting fromvehicle.there was no crash involved, and no one was injured.dealership has not examinedvehicle.please provide any additional information/attachtments.

Driver seat belt will not extend so that it will fit around the driver.

Female buckle base separated thereby making it impossible to lock male portion of shoulder lap belt into female buckle base.tt

Driver seat belt will not extend so that it will fit around the driver.

The driver's side seat belt buckle housing is broken and it keeps jamming.

Failure on the driver and passenger side seat retarctors.tt

Drivers side seat belt retractor fails, not allowing seat belt to be pulled out and worn. Parts on national back order.

The entire back of the front bench seat has bent backwards.

Steering wheel bolts are loosening and coming out.tt

Steering rack binds.

At 30,000 miles vehicle needs a new engine.ttconsumer states steering rackwas replaced.

Hood was replaced.

A small nylon bushing incruise control servo bail has slipped out, causing gas pedal to get stuck. Consumer had to quickly shut off vehicle,but ended up hitting guardrail. The rod slipped out of servo bail and lodged on intake manifold.

A small nylon bushing incruise control servo bail has slipped out, causing gas pedal to get stuck. Consumer had to quickly shut off vehicle,but ended up hitting guardrail. The rod slipped out of servo bail and lodged on intake manifold.




Read more




© 2024 All rights reserved