Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE




We found the following complaints for NISSAN D21 (1992)

Read complaints for NISSAN D21 (1992)


Starter relay failed, causing engine not to crank.

Vehiclewas impossible to start due tomain starter relay going out, happened all the time . Tookvehicle todealer, and the dealer recommended to buy extra relays,so it could be fixednext time around. The part that failed is called a double blue relay.

Replaced the wiring harness for the second since had car purchase car new .tt

Exhaust manifold mounting studs failure.

Headlights go on and off,usually one side at a time.it seems to alternate sides or both go off. The bright light switch some times only one will be off at a time with the other one coming on when ever. It does not seem like a ground is bad since it can be sitting still and the lights will go on or off as they please. I have new lights installed.

Intake manifold failure.

Transmission slips from 1st to 2nd and in o/d and down shifting from 3rd to 2nd bumps, resulting in transmission failure, over drive switch inoperative replaced solenoid and vale body.

5 speed manual transmission jumpd out of 3rd/4th gear, causing grinding. Tt

Driver's shoulder/lap belt buckle/latch wires are fraying, also pass. Side female portion buckle has fallen off.

The driver's side shoulder seat belt popped loose while the driver stretched at a stop light, belt does not lock tightly, dealer contacted, and is not aware of the problem. No warranty and the problem still exists.

Driver side seat belt buckle will not stay latched.tt

Driver's shoulder/lap belt buckle/latch wires are fraying, also pass. Side female portion buckle has fallen off.

Seat broke and through me into the stering wheel when i crashed into the back of another car.

Vehicle was lifted on hoist, and literally broke in half.frame was not visibly damaged prior to incident, and had only small amount of surface rust.rear end of vehicle smashed to ground from 4 feet in the air.very lucky someone was not under it working at the time.frame extremely weak with no visible signs. Vehicle had less that 125,000 miles on it at the time of failure.

Upon purchase of vehicle...previous owner stated that at 32,000 he had to have the frame plated on both sides in front of rear wheels... Do to excessive rust and cracks.i just recently purchased this vehicle with only 57,000 miles on the truck now as of 5/15/2014. The truck sat for the last 3 years because the frame had progressed to the point of non drive ability.both side frame rails from the rear to the front axles are hanging by the fuel and brake lines. Researched the salvage yards an all suitable donors are starting to be the same way.i had another one year an a half ago i had to plate it too.the inside of the beds are all cancer-ed up as well.very poor metal quality and prepping.

Odi# 6141; while driving approximately 65 mphright rear tire tread had separated from tire which caused truck to swerve. Tire is a firestone atx, sizep215/75r15 w/ approx. 25k mileage.tire was a part of the original tires bought with vehicle.vehicle is a nissan pickup truck 1992. Firestone atx p215/75/r15 *mw

Experienced belt separation on all four tires - same problem as recalled tires.this model needs to be investigated and added to recall list.( dot number: tire size: p195/75r14 )

I was traveling along interstate 10, at approximately 60 mph. The visibility was clear; the roadway was clear of any obstructions.the tread on the right rear tire completely separated from the tire.i did not hit anything to cause this tread separation.the tire had just been inspected/rotated by a firestone dealer within the previous month.when the tread separated from the tire, the loose tread hit the rear quarter panel on my truck causing $2,000 worth of damages. (dot number: h4p9djd486tiresize: p195/75r14)

Noisy heater fan.

Steel rims cracked, 1 split causing loss of control of vehicle prior to recall. (92v139)*tw

Upon purchase of vehicle...previous owner stated that at 32,000 he had to have the frame plated on both sides in front of rear wheels... Do to excessive rust and cracks.i just recently purchased this vehicle with only 57,000 miles on the truck now as of 5/15/2014. The truck sat for the last 3 years because the frame had progressed to the point of non drive ability.both side frame rails from the rear to the front axles are hanging by the fuel and brake lines. Researched the salvage yards an all suitable donors are starting to be the same way.i had another one year an a half ago i had to plate it too.the inside of the beds are all cancer-ed up as well.very poor metal quality and prepping.




Read more




© 2024 All rights reserved