Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE




We found the following complaints for MITSUBISHI MIRAGE (1991)

Read complaints for MITSUBISHI MIRAGE (1991)


During rear end collison the air bag did not deploy. Passenger seat came unlocked and flew forward.tt

While driving, the consumer smelled plastic/rubber burning andsuddenly vehicle caught on fire under the hood.the consumer pulled over and called the fire department.the local fire department arrived and extinguished the fire. The vehicle was towed to the dealer for inspection.the consumer noticed a leakage.the consumers daughter was using the vehicle when the it caught fire.the dealer stated that it was an electrical fire.the brake lightwould come on intermittently.the dealer suggested that the combo switch assembly needed to be replaced. *sc

While driving, experienced intermittent engine shut down at high to low speeds, for no apparent reason, no warning.

The computer cuts off and causes the vehicle to stall while driving. Please describe.tt

Intermittent stalling due to computer failure.

Computer malfunctioned.

While driving computer shut off,causing vehicle to lose total power.

Consumerhad to replace the computer in the vehicle.owner states that the vehicle would not exceed 35mph.the dealer replaced the computer a second time, and informed owner that the clutch had a leak, and that was the cause of the vehicle's low speeds.

Starter failed three times.

While driving vehicle,smelled of fuel odor, started getting stronger while driving along, pulled over, turned off ignition, checked under hood, fire burning on top of engine area.

The engine stops unpredictably.i hear a click that seems to come from under the glove compartment, then the engine starts and will not restart immediately.usually, after some minutes, it will restart.it will even stop at high speeds, as it did when i was on the interstate on a long bridge, and could not get out of the way of on-coming semi-trucks.as the dealer advised, i replaced both the computer and the relays, yet the problem persists.

Cpsc#x11c0565a. Cylinder head. 1991 mitsubishi mirage. Consumer stated he purchased the part from d&s light truck and auto parts, inc. He stated the cylinder was bad and they have refused to refund his money or replace the part. *ln

Cpsc#x11c0561a & xx11c0565a. 1991 mitsubishi mirageconsumer stated after installing cylinder head, he noticed the vehicle ran rough. *lnthe consumer was informed the valves needed to be adjusted. The consumer has since learned thecylinder head was bad.

I read with interest the reports of problems with mitsubishi automobiles, as one of the problems reported - a loose crankshaft - is exactly the problem we had with our car. I am reporting this to you as the news accounts i've read talk only about cars imported in the last two years as possibly be subject of recall. I wonder if the recall shouldn't cover cars, like ours, a good deal older than that. Our specific problem occurred in 1996 when the car has about 70,000 miles on it. The crankshaft problem was repaired by phil long mitsubishi in colorado springs. Co.

Crankshaft screw has backed out of the crank, caused damage to the engine.tt

Vehicle has stalled on 3 occasionswithout warning or hesitation ,causing potential safety hazard.

While driving, the consumer smelled plastic/rubber burning andsuddenly vehicle caught on fire under the hood.the consumer pulled over and called the fire department.the local fire department arrived and extinguished the fire. The vehicle was towed to the dealer for inspection.the consumer noticed a leakage.the consumers daughter was using the vehicle when the it caught fire.the dealer stated that it was an electrical fire.the brake lightwould come on intermittently.the dealer suggested that the combo switch assembly needed to be replaced. *sc

Fuel line sensor inside vehicle's tank shorted out, could cause fire or explosion.tt

Automatic transmission failed, sticking in third gear.when vehicle is put into drive the only forward gear is third.

Consumerhad to replace the computer in the vehicle.owner states that the vehicle would not exceed 35mph.the dealer replaced the computer a second time, and informed owner that the clutch had a leak, and that was the cause of the vehicle's low speeds.

Cv boot failure resulted in replacement of cv halfshaft.

Transmission failed twice.

Drivers and passengers motorized shoulder belts do not operate, at times; occupants would be unprotected in an accident.tt

Driver's automatic shoulder belt sticks.

Driver's shoulder belt jams half way; driver feels suffocated because of tightness of belt.tt

Automatic seat belt of front passenger remains locked when door is opened, preventing passenger from existing vehicle. *sd

Poor automatic shoulder belt performance,when the door closes the passenger's side seat belt periodically tends to apply itself too tightly.

Automatic seat belt failed to retract/close after starting engine.

Takata seat belt locks up when closing door; compresses occupant against seat.tt

When door closes automatic front right shoulder belt may not slide back/forward,leaving occupantunprotected. Intermittent problem, not checked by dealer.

Motorbelt jams/ sticks when opening/closing door.

Automatic seat belt will stick before completing cycle majority of usage. Please describe details.tt

Driver's side seat belt broke during the impact of a crash.

Owner received recall notice (#95v103004); called dealer off and on since receiving it.dealer has no parts since 6/96, and does not know when they will be in, but will call owner when they do come in. As of april 16, 1997, dealer has taken care of the repairs.

Driver's and passenger's lap/shoulder belts will not retract,will not release locks in the guide loop.

The passeger side shoulder belt jamming sometimes.

During rear end collison the air bag did not deploy. Passenger seat came unlocked and flew forward.tt

Consumer experienced4 brake failureswhile driving. As a result,on time thevehicle went into a ditch.brake pad separated from the caliper and fell off.this was due to the casting for the brake pad hardly going into the flat. Another time the problem was worse when the pads were new.

Consumer states that the brakes in this vehicle have been replaced twice in the last six months . Consumer is now on the third set.

Brakes replaced twice. *dsh

Consumer experienced4 brake failureswhile driving. As a result,on time thevehicle went into a ditch.brake pad separated from the caliper and fell off.this was due to the casting for the brake pad hardly going into the flat. Another time the problem was worse when the pads were new.

Failure on the brakes, having a very hard time with stopping the vehicle, causing the consumer to have an accident, due to warped brake rotor.

Tires had 30 thousand miles on them.tire size was155r13. Tires mounted on a mitsubishi, mirage, 1991. While vehicle was parked for over three hours, the left front tire blewout.also, there were some cracks aroundrim. Tires were replaced.

The vehicle came to a complete stop when attempting to switch from "drive" to "park" without warning,a sudden acceleration was experienced, causing the vehicle to hit a barrier.




Read more




© 2024 All rights reserved