Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE
Use this form now and GET 20% DISCOUNT for CarVertical reports!




We found the following complaints for MERCEDES BENZ 124 (1995)

Read complaints for MERCEDES BENZ 124 (1995)


The check engine light came on. The dealer, after diagnosing the problem, said that a code indicating that the temperature sensor was faulty however they determined that the wiring harness was deteriorated and needed to be replaced because "this year car was designed with a harness that was biodegradable." the insulation has begun to crumble requiring a new harness. The part is about $1100 plus labor for installation.

The engine wire harness had melted in two locations. When i bought the car the previous owner told me that he had replaced the engine wire harness.

Engine wiring harness insulation has disintegrated, cracked and flaked off of the wires exposing significant amounts of bare copper including connections to the glow plug relay and every connector directly attaching to an engine component.removal of the wiring harness shows cracking and disintegration if the harness insulation throughout the entire length of the harness. Was causing instrumentation malfunctions in glow plug circuits. Significant exposed power wire copper would ground the system out if even a slight shifting of the harness took place as would happen in any minor accident. I have saved several examples of the defective wiring.

The car started to lose power at a slow speed at any stop. The engine almost dies if you don't give gas. The check engine light came on.

The engine wire harness had melted in two locations. When i bought the car the previous owner told me that he had replaced the engine wire harness.

Engine wiring harness insulation has disintegrated, cracked and flaked off of the wires exposing significant amounts of bare copper including connections to the glow plug relay and every connector directly attaching to an engine component.removal of the wiring harness shows cracking and disintegration if the harness insulation throughout the entire length of the harness. Was causing instrumentation malfunctions in glow plug circuits. Significant exposed power wire copper would ground the system out if even a slight shifting of the harness took place as would happen in any minor accident. I have saved several examples of the defective wiring.

Right front spring perch and surrounding rail is crumbling. One leg of the perchat the weld has completely broken lose. There is no other significant rust on the vehicle. If this fails, the spring may break through the rail into the engine compartment, or the spring may fall out.at speed, this could be a very bad situation.

This car has only 33000 miles and this kind of problem should't be happening .i talked to the dealer they were not helpful about it.only thing they say it is not under waranty.i dont understand that i this car ever been recalled for this kind problem?




Read more




© 2024 All rights reserved