We found the following complaints for JAGUAR VANDEN PLAS (1996)
Read complaints for JAGUAR VANDEN PLAS (1996)
Computer chip failure.qcaw
Transmission failed.
Right rear bracket that holds the drivers seat to the mounting track broke.this allowed the drivers seat to swing back on acceleration and swing forward, into steering wheel, when applying the brakes.the seat would swivel around on the three remaining attach points.this occurred during normal driving.if this had happened as a resujlt of a rear end collision, it is likely that the entire seat would have torn loose and become an unguided flying object in the car.given that the seat belt is attached to the seat frame rather than the car's frame, it would have provided no protection.if the airbag were to have deployed, the force of it would also have knocked the seat, cocked at an angle and with the driver strapped in it, across the back of the car and into any passenger sitting back there.i have detailed photos on the broken bracket and the frame mounting from which it separated.
Vehicle failure due to failed wire strands.addto voq 10041323.*mr of seven strands it appeared that four or five may have been "trimmed" during manufacturing process leaving two or three strands to carry the current. Adjacent wires show damage from heat. On two wires the insulation is cracked sufficiently so that the wire strands are visible. Consumer believe the repair should've been at no charge due to defective product and perhaps design by placement of the wire crimp at point of flexure. *ph
Consumer stated on 2 separate occassions, the accelerator pedal became stuck, and the accelerator had to be stomped on in order to dislodge it, the dealer repaired the problem under warranty the first time, however the second time consumer was informed that it was a maintenance item and that it would have to be fixed every 10,000 miles at the consumers expense, consumer is requesting reimbursment and feels this problem should not be considered a maintenance issue.
Vehicle1996 jaguar vanden plasvin#[xxx]problemfailure of windshield wiper/washercausebroken wire at crimped junction in wiring harness that supplied power to control switch i had hoped to be able to get a photomicrograph of the failed wire. Of the seven strands it appears that 3 or 4 may have been trimmed leaving 2 or 3 strands to carry the current. Adjacent wires show damage from heat. On two wires the insulation is cracked sufficiently so that the wire strands are visible.this harness is subject to various degrees of flexure as the steering column lifts and retracts from the programmed drivers positions. The failure was 2.1 [55 mm] from the 10 pin connector that is rigidly clipped in place. Information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6).
Read more
