We found the following complaints for HYUNDAI SCOUPE (1991)
Read complaints for HYUNDAI SCOUPE (1991)
This is a used car, i can only assume that the first time the computer failed, was indeed the first time. It initially failed in november of 1999. I replaced it with a used computer which subsequently failed in august of 2000. I am currently having it replaced with a new computer.
Transmission failed, wiring harness failed.
Fan switch failed resulting in engine overheating.
Rocker shaft snaps in half, throwing end bolt into valve cover. *dsh
Head gasket failed, causing engine to overheat.*aw
Engine oil leaks continuously, engine also jerks and bucks, finally replaced due being cracked.
Muffler fell off.
The cigarette lighter once ready popped completely out and under the drivers seat, almost causing an accident.tt
Head lamp assembly failed.
Fuel pump failed.
Car down shift transmision went out purchase car new.tt
Consumer purchased used vehicle having problems with transmission.tt
Transmission failed, wiring harness failed.
Transmission locked up while moving, and now 2yrs. Later vehicle needs a replacement.tt
This car has been taken into the dealer three times in 1992 for transmission problems and has never fixed the problem.there have been several phone calls to dealer in past years but were unable to identify the problem.this car has always had jerking on excelleration, fast idle when doing 20, 30and 40 mph.it now stalls and slips out of gear.it has lurched forward in the past from a stop.this car has never run right as far as the transmission is concerned but hyundai does not want to fix the problem.
Transmission failed twice, causing vehicle to stall.*skd
Brakes failed while driving, completely fell apart.
Consumer was sold a vehicle from salvage. *mr (according to b1381 the seller was supposed to disclose this info to the consumer)there was a broken motor mount, both cross members were bent, very poor welding on the right side of the subframe, the cover support was bent, the rack and pinion was leaking, the upper tie bar was bent, and the p/s fluid was extremely low. *sc
Consumer was sold a vehicle from salvage. *mr (according to b1381 the seller was supposed to disclose this info to the consumer)there was a broken motor mount, both cross members were bent, very poor welding on the right side of the subframe, the cover support was bent, the rack and pinion was leaking, the upper tie bar was bent, and the p/s fluid was extremely low. *sc
Drivers side door handle broke and you could not get out of the car, now the passengers side does not work.tt
Consumer stated that the driver's side door does not open frominside or outside,preventing the occupant from entering and existing the vehicledue to a broken part inside the door panel. Consumer has yet to contact the dealer.
Hood flew open while driving2nd time while driving.tt
Power window regulator switch failed.
Passengers side window fell down.
Windshield wiper motor assembly failed.
Read more
