Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE




We found the following complaints for HONDA VT750C (2005)

Read complaints for HONDA VT750C (2005)


This has existed since new.the transmission during acceleration and just after shifting to a higher gear will release, rev in a false neutral and jump back into gear, most times to the next lower gear.this mostly happens between third and fourth gear when accelerating hard but has happened going from fourth to fifth.this causes the back wheel to lock up and skid till rpm matches with wheel traction.honda first adjusted the clutch on the handlebars, didn't work.two weeks later they had it for two weeks and changed out the entire shifting linkage but after about 70 miles the same problem recurred three times an always going from third to fourth.it was back at honda (house of power, palm bay, fl) again this week and they took it for a five minute ride and said they could not duplicate the problem.i had explained the intermittent problem and that it had happened across miles of driving.it also sometimes revs a little like the clutch is slipping.their answer is since they could not duplicate the problem they can do nothing for me. .....ak

Dt*: the contact stated that the front brake caliper fell off the new motorcycle while driving 10-15 mph.the contact plans to contact the dealership and honda today concerning this problem. Updated 7/3/2006 - the dealer reattached the caliper and checked all other major components to see if they were torqued to specs.the technician found that the front fender bolts and the bolts to the exhaust manifold were loose.all boltswere re-torqued.

Dt*: the contact stated that the front brake caliper fell off the new motorcycle while driving 10-15 mph.the contact plans to contact the dealership and honda today concerning this problem. Updated 7/3/2006 - the dealer reattached the caliper and checked all other major components to see if they were torqued to specs.the technician found that the front fender bolts and the bolts to the exhaust manifold were loose.all boltswere re-torqued.




Read more




© 2024 All rights reserved