Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE
Use this form now and GET 20% DISCOUNT for CarVertical reports!




We found the following complaints for HONDA PRELUDE (1986)

Read complaints for HONDA PRELUDE (1986)


Engine does not idle very well when warm or very cold. Car seems to loss power on the freeway. Car tends to oveheat after long driving stints. Fan does not go on when engine is over heating.

Vehicle stop running/loses power while driving.

Vehicle fuel system experienced failure on multiple occasions, prior to recall notice and after recall repair (92v028001).

This defect is covered by nhtsa camaign id 92v028001 and is a fire hazard.this vehicle was manufactured in japan and as such dealers will not repair at no charge.the warranty states "except as may be required by law, this vehicle has no warranty in the 50 united states, d.c., puerto rico or the u.s. Virgin islands."my question: is this recall required by u.s. Law and therefore should be performed at no charge? if so how do i proceed?

Recall 92v028001;fuel filler and cap rusted through which may cause a fuel leak and a fire.there is a recall, but this vehicle is not included because vehicle was made according tocanadian standards.please provide further information.

Honda recalled this car in order to replace the gas tank filler pipe due to excessive corrosion, however, the surrounding mounts and the fill pipe bowl on the filler door are also excessively corroded, and are failing to hold the filler pipe in place, and allow excessive fumes to build up within the car.the stamped metal bowl surrounding the filler pipe at the gas door has failed, and should be replaced along with the filler pipe that was recalled.

Vehicle leaking fuel from tank after recall repairs made for that system causing lower milage per tank.nlm

Defect in fuel filler pipes--certain environmental conditions could cause corrosion.owner wants to know if there is a recall, being that there is a recall for the honda accord of the same year for the same defect.

Front seat belts are not long enough to fasten when seats are in forward position.*skd

The metal fastner doesn't engage into seat belt locking mechanism properly.tt

The rear drive side retractor is lock up purchase car used.tt

Reclining mechanism failed on drivers seat.tt




Read more




© 2024 All rights reserved