We found the following complaints for HARLEY-DAVIDSON VRSCF (2011)
Read complaints for HARLEY-DAVIDSON VRSCF (2011)
The contact owns a 2011 harley-davidson vrscf. The contact took the vehicle to rahway harley-davidson (12 west milton ave, rahway, nj) to be repaired per nhtsa campaign number: 18v076000 (service brakes, hydraulic). The technician refused to perform the repair because the abs was defective. The contact was informed to have the abs repaired. The manufacturer was notified and refused to cover the cost of the abs replacement. The contact stated that the owner's manual stated that the abs flushing should be performed by the consumer every two years. Due to the verbiage in the manual, the contact stated that the manual did not indicate that abs flushing must be performed at the dealer. The failure mileage was approximately 12,000.
There is current recall on this hd motorcycle. The safety recall is m140: safety recall 0171. The recall required hd to replace the brake fluid with platinum label dot4. According to the safety recall, the old brake fluid "can cause the brake system damage and adversely affect braking, which could result in death or serious injury."the brake fluid on this motorcycle was replaced every two years but not through hd. In september 2020, the brake fluid was replaced per the safety recall at hd. While i was riding the motorcycle, the rear brakes stopped working altogether. There was no electronic warning on the computer. The faulty abs caused a blockage and would not allow the brake fluid to pass through the abs hydraulic unit. Fortunately, i was able to continue the ride using the front brakes only until it was safe to get back to the house.i took the motorcycle to huntington beach hd in california and they reached out to hd support to see if they could help with the abs. Hd claimed that it was due to neglect.as i see it, this is a major safety issue. The abs unit is a faulty unit which could have easily killed its driver since it stopped working in one event. It is not the typical electronic warning nor was it a failure where the brakes would slowly reduce its function over time. This abs unit, will kill the brakes altogether in one event.to save lives, i feel that hd should offer another safety recall not only to replace the brake fluid but also all faulty abs units that are installed on these motorcycles.the rear brakes was non-functioning and does not depress.
I am from australia but i own an american made harley-davidson vrscf muscle motorcycle. The motorcycle is equipped with abs which does not work.i purchased the motorcycle from the harly-davidson dealer (fraser motorcycles) in perth, western australia on 5 november 2010.!0days after initial purchase the abs warning light came on while the motorcycle was running/ i have referred this to the dealer but so far they have not been able to ascertain why the abs system is not working.
07/26/2011 -2011 h-d vrod muscle (vrscf) i was traveling on the interstate and got off at my exit.as i was downshifting the left foot peg assembly came lose and rotated down.i was only a half mile away from home using residential streets.as i got on my street the entire foot peg assembly came out of the frame and fell onto the street.at this point i had no place to set my foot and was not able to change gears.if i were still on the interstate this could have been a devastating incident.i examined the foot peg assembly and the bolt the keeps the assembly in place had sheared off.the bike was fixed at dealership under warranty.11/04/11 - i was backing my vrscf out of my storage shed in neutral.after backing up went to put the bike in hear and the left foot peg assembly again came lose as before because of a sheared bolt.when i went to the dealership to get a new bolt i noticed the2012 models of the vrsc have an entirely new way of attaching the foot peg assembly to the frame.i contacted h-d and the sheared bolt is being sent to them via usps for them to examine.others with similar issues:http://www.1130cc.com/forums/showthread.php?t=34991http://www.1130cc.com/forums/showthread.php?t=124227http://www.1130cc.com/forums/showthread.php?t=145800.
I am from australia but i own an american made harley-davidson vrscf muscle motorcycle. The motorcycle is equipped with abs which does not work.i purchased the motorcycle from the harly-davidson dealer (fraser motorcycles) in perth, western australia on 5 november 2010.!0days after initial purchase the abs warning light came on while the motorcycle was running/ i have referred this to the dealer but so far they have not been able to ascertain why the abs system is not working.
This is not the first time i have reported this issue. Today, dec 22, 2018 at 1030 am. While riding my motorcycle down i-264 in virginia beach, va. The single bolt that holds the right drivers footpeg in place sheared, causing the footpeg to drop, leaving me without a place to put my foot and caused a hindrance to my ability to use the rear break.
Read more
