Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE




We found the following complaints for GMC YUKON XL (2006)

Read complaints for GMC YUKON XL (2006)


Driver seat not moving forward i've seen other complaints about this also the gas gauge isn't work nor is the speedometer we replaced stepping motors still not working this is a safety hazard knowing how fast i'm going..

Codes p1516, p2135, and p0120 have returned for a third time. I was driving and my car went into reduced power mode. Luckily, i was just a mile away from home and limped my car home. I've since cleaned the mass air flow sensor and throttle body. I've changed out the tps and acceleration sensor. I've checked all my grounds and these codes keep coming back. I've noticed other people having this same issues which is why i did the steps listed above. I've taken it to a mechanic who said that i did every step they've would have done to troubleshoot this problem. Someone from gm needs to this issue, as i am not the only one that this is occurring to.

From the stopped position gas pedal goes dead at accelleration. This is super dangerous when moving onto a traffic situation. The vechicle stall and a gringding sound appears. This happen i ntermitently. Gmc recalled outh gmc yukons to correct this deffect but not mine. Please help

Electronic stability control activates and deactivates randomly. Unsure as to the safety of this random actions, but it does effect the control of the vehicle.

Electronic stability control activates randomly. While accelerating from a complete stop the vehicle goes into traction control or reduced engine power.stalling in the middle of intersections or at stop lightscar behind expects you to move and you cant. You have to either turn car off and back on or put in netural to try and get your car to go this is a very dangerous problem that leaves you feeling helpless and no control of your vechical i pray that this is looked into before someone gets hurt i also reported this to gmc

While accelerating from a complete stop thevehicle goes into traction control for no reason stalling in the middle of the intersection.the display flashes traction active even though the pavement is dry and free of loose debris.you have to let the accelerator go and re-accelerate to deactivate the traction control, leaving you stalled in the middle of the intersection.gm had a recall for large suvs and pick-ups with a very similar problem,the only difference was the display flashed an abs fault but the repair for that recall was exactly the same as for the traction active fault.abs is part of the traction control system,so just because gm found a way to throw a different code for the exact same problem they're not obligated to take care of this potentially very dangerous problem that leaves you in no control of your vehicle in the middle of an intersection while moving from a stop light or stop sign.please look into this before somebody gets hurt or dead from getting t-boned because they can't get out the way.

Periodic "traction active" indicator light along with gas pedal inoperable. Became more frequent and during long road trip for work, almost got into 3 accidents. Only occurs when starting out or during acceleration while going slow. Twice at stop sign while crossing busy intersections, vehicle died in middle of intersection when pulling out for several seconds. Caused traffic to stop and almost had collision.once happened while making left turn at intersection. Same results. Saw many similar complaints on forums about gmc yukon. Usually happens after 40k (warranty expired) i just went over 40k last week. Seems like problem started back in 2003 version, from all other complaints i read about. Repair: dealer found incorrect readings from right front wheel speed sensor, sensor only available as part of rf hub assy. Pn 015233113 $377.36 ($600+ installed) i explained all other complaining about same problem and how this is a very big safety issue. Dealer said they can do nothing.

While driving my suv on the freeway, the abs ,traction controll,brake lite on the instrument cluster started flashing and chiming. Service stability was flashing on the dic. The dealer said the abs module needs to be replaced. There is a loss of hvac controll ,no ac and ventillation or heating,loss of cruise control. Please advice.

The contact owns a 2006 gmc yukon xl. The contact stated while driving approximately 40 mph, there was a complete loss in the engine power for a brief moment. The vehicle then resumed normally.the failure recurred two times. The vehicle had not been diagnosed or repaired. The manufacturer was not notified of the problem. The failure mileage was unavailable.

Electronic stability control activates randomly. While accelerating from a complete stop the vehicle goes into traction control or reduced engine power.stalling in the middle of intersections or at stop lightscar behind expects you to move and you cant. You have to either turn car off and back on or put in netural to try and get your car to go this is a very dangerous problem that leaves you feeling helpless and no control of your vechical i pray that this is looked into before someone gets hurt i also reported this to gmc

I noticed a gasoline odor coming from my fuel tank area, i immediately had amechanic inspect the issue as i was fearing a possible fire hazard. Upon inspection he found the fuel lines to the fuel pump to have disintegrated and spewing fuel . The fumes and fuel were dangerously close to theexhaust system and i fear that i just narrowly averted disaster. Further inspection by the mechanic determined that the brake lines were also about to rust through and the effect of that would be catastrophic in a highway or any hard braking situation that could initiate enough pressure to cause the lines to burst.i am very upset that gmc hasn't apprised owners of this hazardous and life threatening situation with these vehicles. I have replaced all affected components and feel that this is cause for a recall and reimbursement from gmc beforea catastrophic event takes place due toblatant negligence of the manufacturer. My understanding is many people have voiced concern over this and gmc has turned a blind eye.

The contact owns a 2006 gmc yukon xl. While at a stop, the vehicle lost power and the traction control warning indicator illuminated. The vehicle accelerated eventually. The failurerecurred several times. The vehicle was taken to an independent mechanic who performed an on-screen driving test, but was unable to find the failure codes. The dealer was contacted (john paul's gmc, greenfield, wi, 414-482-6246) and the technician stated that the failure could not duplicated because the dealer used the same diagnostic system as the independent mechanic. The vehicle was not taken to the dealer. The manufacturer was notmade aware of the failure. The failure was not repaired. The failure mileage was approximately 180,000.

Full brake failure in 7/19 and again in 10/19. We were able to avoid hitting other vehicle as little traffic. Had them completely repaired both times.1/20 brakes failed again causing us to avoid hitting other vehicles by jumping a curb and hitting a mile marker sign a parkway. That is 3 brakes failures in 7 months. Vehicle is now totaled. This seems to be a huge issue!no injuries, thank god!

Steel brake line corrosion caused brake line to rupture causing brakes to fail.

While accelerating from a complete stop thevehicle goes into traction control for no reason stalling in the middle of the intersection.the display flashes traction active even though the pavement is dry and free of loose debris.you have to let the accelerator go and re-accelerate to deactivate the traction control, leaving you stalled in the middle of the intersection.gm had a recall for large suvs and pick-ups with a very similar problem,the only difference was the display flashed an abs fault but the repair for that recall was exactly the same as for the traction active fault.abs is part of the traction control system,so just because gm found a way to throw a different code for the exact same problem they're not obligated to take care of this potentially very dangerous problem that leaves you in no control of your vehicle in the middle of an intersection while moving from a stop light or stop sign.please look into this before somebody gets hurt or dead from getting t-boned because they can't get out the way.

While driving my suv on the freeway, the abs ,traction controll,brake lite on the instrument cluster started flashing and chiming. Service stability was flashing on the dic. The dealer said the abs module needs to be replaced. There is a loss of hvac controll ,no ac and ventillation or heating,loss of cruise control. Please advice.

Brake lines very rusted and leaking fluid both fronttorearlines needed to be replaced.had to also replace rear brake pads & rotors they were pitted and grooved. Needed to perform brake fluid flush , both rear axle seals leaking & rear cover gasket seal leaking on parking brake shoes all needed to be replaced. I heard there was a problem with older modle suv's and had mine looked at and was advised not to drive until these repairs were completed.i have all repair invoices to vehicle.

My stability traction control system engages in dry weather when accelerating from a stop, additionally, the system engages at moderate speeds which causes the vehicle to slow speeds in traffic. Also, the anti lock brakes engage in dry weather at slow speeds when braking.these situations have occurred on several occasions for the last several months

Electronic stability control activates randomly. While accelerating from a complete stop the vehicle goes into traction control or reduced engine power.stalling in the middle of intersections or at stop lightscar behind expects you to move and you cant. You have to either turn car off and back on or put in netural to try and get your car to go this is a very dangerous problem that leaves you feeling helpless and no control of your vechical i pray that this is looked into before someone gets hurt i also reported this to gmc

On june 12, 2008 had my oil changed and was informed that my front pinion seals were leaking on my 2006 yukon. On june 13, 2008 i had them service at my local midas dealer. On june 18, 2008 i blew my front axle out pushing the transmission fluid out taking 4th gear out of my transmission. Gmc has my yukon now repairing @ $4,000.00 claiming midas is at fault and midas is claiming gmc is at fault.

While accelerating from a complete stop thevehicle goes into traction control for no reason stalling in the middle of the intersection.the display flashes traction active even though the pavement is dry and free of loose debris.you have to let the accelerator go and re-accelerate to deactivate the traction control, leaving you stalled in the middle of the intersection.gm had a recall for large suvs and pick-ups with a very similar problem,the only difference was the display flashed an abs fault but the repair for that recall was exactly the same as for the traction active fault.abs is part of the traction control system,so just because gm found a way to throw a different code for the exact same problem they're not obligated to take care of this potentially very dangerous problem that leaves you in no control of your vehicle in the middle of an intersection while moving from a stop light or stop sign.please look into this before somebody gets hurt or dead from getting t-boned because they can't get out the way.

While driving my suv on the freeway, the abs ,traction controll,brake lite on the instrument cluster started flashing and chiming. Service stability was flashing on the dic. The dealer said the abs module needs to be replaced. There is a loss of hvac controll ,no ac and ventillation or heating,loss of cruise control. Please advice.

Periodic "traction active" indicator light along with gas pedal inoperable. Became more frequent and during long road trip for work, almost got into 3 accidents. Only occurs when starting out or during acceleration while going slow. Twice at stop sign while crossing busy intersections, vehicle died in middle of intersection when pulling out for several seconds. Caused traffic to stop and almost had collision.once happened while making left turn at intersection. Same results. Saw many similar complaints on forums about gmc yukon. Usually happens after 40k (warranty expired) i just went over 40k last week. Seems like problem started back in 2003 version, from all other complaints i read about. Repair: dealer found incorrect readings from right front wheel speed sensor, sensor only available as part of rf hub assy. Pn 015233113 $377.36 ($600+ installed) i explained all other complaining about same problem and how this is a very big safety issue. Dealer said they can do nothing.




Read more




© 2024 All rights reserved