We found the following complaints for GMC YUKON XL 2500 (2002)
Read complaints for GMC YUKON XL 2500 (2002)
2002 gmc yukon xl 8.1 vortec engine turns off.possibly crankshaft position sensor.
Vehicle stalls while at speed. Has occurred several times. Mechanic finds no problems with engine, cooling system,or fuel system. In each case, vehicle stall resulted in loss of power, power steering and power brakes, creating a dangerous situation. Problem has not been resolved.
Ref - pe06016 - vehicle stalls while at speed.has occurred three times.mechanic finds no problems with engine, cooling system, fuel system, but finds a diagnostic code of a crank position sensor failure.in each case, vehicle stall resulted in loss of power, power steering and power brakes, creating a dangerous situation.problem has not been resolved but based on other reports will replace the crank position sensor.
The engine can stall intermittently at highway speed without warning. This situation can severely impair high speed steering and braking ability. After stalling engine will not start while coasting it will start normally after coming to a complete stop.
While bleeding the brake system after a brake job the steel brakes lines failed.during the inspection of the steel lines it was found that all the steel lines were rusted severely to the point of failure.failure meaning a large hole in the steel line from rust.all steel lines will have to be replaced.
The contact owns a 2002 gmc yukon xl 2500. The contact stated that brake fluid was leaking from the vehicle. The contact noticed that when the brakes were applied brake fluid would spew out from the brake lines. The vehicle was not taken to the dealer.the manufacturer was not notified of the failure.the approximate failure mileage was 59,000.
One of the two steel brake lines between the master cylinder and the abs module failed upon application of the brakes while the vehicle was in motion, causing a severe brake fluid leak near the abs module, low brake pedal efficacy, low brake pedal return pressure and substantially increased stopping distance as i maneuvered the vehicle to a safe stopping location.
The contact owns a 2002 gmc yukon xl 2500. The contact stated that brake fluid was leaking from the vehicle. The contact noticed that when the brakes were applied brake fluid would spew out from the brake lines. The vehicle was not taken to the dealer.the manufacturer was not notified of the failure.the approximate failure mileage was 59,000.
Read more
