We found the following complaints for GMC 1500 (1994)
Read complaints for GMC 1500 (1994)
My brake lights don't work ived tried every thing to fix them and i cant seemed to find the problem i was wondering if the wireing or brake switch were recalls
Consumer states he is having a problem with his gmc 1500 once he puts the key in the ignition and starts the vehicle. When it is time to turn the vehicle off he cannot cut it off.it is hard to engage the the swift level to park and remove the key.he is killing the starter. Consumer has worked on trucks for a long time and has never encountered this type of problem.
Brake light will not work. Dealer notified, and repaired/ replaced fuses. Brake light still not working.
Brake problem started shortly after purchase. Dealer admitted there was a problem, but was unable to fix problem. Front brakes do all the braking, rear brakes are in new condition after 90000 miles.the driveline experiences a clunk.the trip setter is faulty, consumer is waiting for dealer to replaced the dash/gauge assembly.
Intake manifold has cracked, causing gasolineto seap through. Manufacturer has been contacted.
Brake problem started shortly after purchase. Dealer admitted there was a problem, but was unable to fix problem. Front brakes do all the braking, rear brakes are in new condition after 90000 miles.the driveline experiences a clunk.the trip setter is faulty, consumer is waiting for dealer to replaced the dash/gauge assembly.
Vehicle was parked inside ofgarage, and it rolled out of the garage into a tree. Consumer stated that thiswas the third time this happened.
Driver's and passenger'sautomatic seatbelts will not release. They are stuck or jammed.consumer is not able to fasten seatbelts.consumer took vehicle to dealer, and they repaired the drivers side.but, passenger's side still is not usable.
A faulty bolt caused the driver's seat to break.when the bolt broke it was hard to see out of the windshield*nlm
While driving driver's bucket seat collapsed backwards, forcing consumer to hold on to steering wheel and keep control of vehicle. Then he saw that thebolts holding the seat broke.
Bolt failure of seat frame may cause seat to suddenly recline allowing driver to possible lose control of vehicle.(recall campaign 95075)
Seat latchwas repaired undermanufacturer's recall 94c62, oct. 20,1997. Since then has broken again on 0ct. 2,1999. Dealer has been contacted.
When driving at any speed and applying the brakes, brake pedal goes straight to the floorboard.three or four instances over the past years but two instances so far this year 1999.dealer can't determine cause of the problem.
Brake problem started shortly after purchase. Dealer admitted there was a problem, but was unable to fix problem. Front brakes do all the braking, rear brakes are in new condition after 90000 miles.the driveline experiences a clunk.the trip setter is faulty, consumer is waiting for dealer to replaced the dash/gauge assembly.
Brakes willnot hold when they get hot, pedal is soft and goes al the way to the floor, dealership is aware ofproblem.consumer stated this conversion van front brake pads only lasts 14000 this is the 4th set of brake pads.
Abs brake system failed.went to purchase new tires and was told rotors were shotted.
Steering is too sensitive whiledriving at60mph. Consumer contacted dealer and manufacturer.
While driving about forty mph went to change lanes, and steering wheel would not turn left orright, causing consumer to crash.
The tread separated off two new uniroyal laredo p235/75r15m+s tires within one month after they were installed on the gmc pickup. (dot number: aphlf3u343tiresize: p235/75r15)
1994 gmc sierra pickup ([xxx])gm has 2 recalls for windshield wiper motor problems on 1994 and newer pickups and suvs (recall 98043 and special policy adjustment 02054a).my vehicle has the same problem noted in the recalls: intermittent wiper operation resulting from cracked solder joints on the wiper motor control's printed circuit board at its connection to the wiring harness.but, because my vin does not match those in the recall, i am left to deal with this problem on my own.i have been living with this for a few years because i don't have the time or money to fix it.and, my brief internet research reveals numerous other gm owners in the same situation ... The same problem identified in the recall but left in the cold by gm because of vin number exclusions.my call to gm revealed that the recall was limited to vehicles manufactured at certain plants, because only those plants used parts from "defective batches."the root cause of the problem (bad solder joints) seems to me a design issue (failure to mitigate vibration, too rigid a connection between the wiring connector and pcb?), not a manufacturing defect (bad batch of material, improperly soldered joint?).same symptoms resulting from the same failure on the same part with the same part number?when i pressed the customer service rep. On this question (vin number and parts batch are irrelevant if it is a design flaw, which i think it is), i got the proverbial run-around.and, my wipers still don't work. Updated 07/24/2012 information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6)
While driving 35mph in the rain, windshield wipers just shut off, causing driver to brake. Driver has no confidence in wiper operation.this part was recalled #98v150, however this vehicle was not included due to the vin.the windshield wipers intermittently work.*jg
While driving 65mph in rainwindshield wipers stoppedworking.
Windshield wipers failed to work properly when in use.problem is intermittent. Had taken to dealer, andwas informed by mechanic no technical service bulletin for wipers. Vehicle at dealer's.
Wipers on my 1994 gmc pick-up do not work at all times when required. This is a definite safety issue. This problem has occurred routinely for the last several years.gmc acknowledged other complaints of this nature; however, my vehicle is not covered under their recall orders, my contact with gmc produced negative results. *la
Windshield wipers run intermittently severely limitiing visibility which could result in a crash. Gmc notified me that my vehicle vin number was not part of the wiper motor replacement recall even though i am experiencing the same problem.
Windshield wipers failed intermittenly. A recall was issued. However, thisvehiclewas not included due to vin.
Windshield wipers malfuntioned stoped working.has been unreliable since then.
While drivingvehicle in the rain windshield wipersfailed. This caused the driver to pull off the road. Consumer contacteddealership, butproblem recurred.
Windshield wiper motor just quit working, consumer was unable to see clearly.
In a heavy rain storm windshield wipers failed.heard a buzzing noise in the motor.contacted dealer & manufacturer.
Windshield wipers malfuntioned stoped working.has been unreliable since then.
Rear wheell fell offdue towheel studs breaking off.
Read more
