We found the following complaints for FORD F350 (1990)
Read complaints for FORD F350 (1990)
Vehicle stalled then exploded, causing injury.
Ignition switch replaced. *sd
While driving, smelled smoke; pulled to side of road; engine compartment was on fire; cause unknown; seemed to burn from bottom up; totaled.tt
Back of the fuse box melted, and consumer lost electrical power.
Engine blew a head gasket.
Oil pressure sending unit failed.
Diesel engine replaced. *sd
Consumer was traveling 60 mph & vehicle stalled. Rearfuel tank spilled gas all overhighway. Whenvehicle was being towed toford dealerfuel tank fell off.shield that guards the tank dropped &gas lines were disconnected.
Engine was losing raw fuel from a leak which was goinginto the exhaust system. This caused the catalytic convertor to burn. Have been to service center.
Consumer received letter of concern (98c01) which discusses engine problems, however vehicle experienced severe engine failure due to lack of prior notification, denied reimbursement costs of repair.*mjs
Engine failed two times due to contamination as per recall notice.
Truck was in use when it began to emit a white vapor from exhaust, after head removed found ok,discovered 8 cylinder had become porous, causing antifreeze to enter the combustion chamber which caused the vapor and hydro-lock.
Number 8 cylinder became porous causing the antifreeze to enter the combustion chamber which caused vapor and hydro-lock (emit white vapor from exhaust).
Engine was losing raw fuel from a leak which was goinginto the exhaust system. This caused the catalytic convertor to burn. Have been to service center.
While driving emergency spare tire underneathvehicle caught on fire.fire wascaused by exhaust pipe being too close.manufacturer notified. Feel free to provide any further information.
I am speaking on behalf of the owner, i am ted schore of ocala,fl pineywoods automotive 352-629-6727 the customer had the truck towed in because of a no start (battery was bad) and after the repair and running noticed a fuel smell and large fuel leak from the bell housing area. The leak was from the fuel return line from the pressure regulator to the connection to the line from the tank, approx 12 inches long and metal. The pinch weld above the bell housing rubbed the line through. I check for service bulletins and recalls and found a recall number 94s80, i called the local ford dealer to arrange towing and for the recall to be performed and was told the recall had already been done by bay harbor ford in englewood florida. I called the 1-800 number given to me by the local dealer (dearborn?) and was told the it had indeed been done but they were not going to do anything about it now, i informed them that although they show it being done that it was not they pretty much said it was not fords problem and the customer would have to pay to have it repaired. Well my problem is this. The bay harbor ford has been paid to perform the recall but it has not been done. The old line was metal where the new recall was for a plastic line, the kit also had a vinyl trim piece to cover the pinch weld that rubbed the line in the first place. The kit number from ford was f4tz-9j332-a i was told it was on national back order but the parts man was able to get it through another ford dealer. I just wanted to inform you of this because it was a real fire danger and unsafe to drive. Ford"s attitude was just plain wrong. I would think that the dearborn office would have paid to have the truck towed to the nearest dealer, inspected, made note of the recall not being done, performed the recall and go after bay harbor ford, but in so many words i was told tough.i think i saved them from a big lawsuit as the customer hauls horses. Big dollar horses.
Fuel pump failed.
Fuel injectors failed.
Vehicle was taken to dealerforrecall repairs about 5 years ago. Vehicle had duel gas tanks. The recall was issued because one tank would pump gas into the other tank,and when it was full it would spill over, creating a fire hazard. After recall repairs were done the problem recurred. Consumer felt that the proper work for the recall was insufficiently done because of what was happening currently.
93 v 125 000/fuel tank assembly: vehicle experienced a portion ofunused fuel from one tank to be returned tosecond tank. When this occurredsecond tank exceeded, causing fuel spillages. Spilled fuel could result in a fire when exposed to a source of ignition.dealer notified, and informedconsumer thatvinshowed that recall repairs were done on this vehicle.but problem has reoccurred,and dealer refused to help in this matter. Please feel free to provide any further details on this matter:
When filling up both dual tanks fuel spits back out and that could cause a fire.
Dt: the cross over of the fuel improperly overfills the second tank, spilling fuel out of vehicle. There were 2 safety recalls of this item. But ford was saying that one recall was taken care of by a previous owner.the second recall expired, and ford will not fix this problem. Ford has been contacted by the customer and the repair facility. Ford was still not willing to help. This has been a problem for a couple of months. The customer was having it repaired at his own expense. If there was a safety issue on this problem it should be taken care off by dealer no matter how many times it comes up.
Fuel tank selection switch failure.
Consumer was traveling 60 mph & vehicle stalled. Rearfuel tank spilled gas all overhighway. Whenvehicle was being towed toford dealerfuel tank fell off.shield that guards the tank dropped &gas lines were disconnected.
There has been multiple recall notices for the ford f-series dual fuel tank design flaw. When both tanks on my truck are filled to capacity, one tank will empty its contents into the other full fuel tank and will spray out fuel on to the road and other vehicles posing a great fire hazard. Each time i have taken my truck in to have the recall performed on my truck by the local dealer (mccullom ford in spokane wa)they have returned my truck without fixing the problem. They have indicated that they have performed fords recommended fix and that it has not solved the problem. This is a ford motor co. Design flaw. I would like more information on how i can have this unsafe condition addressed. Thank you.
Automatic transmission bushing failed twice due to design.
Transmission has failed five times.
The torque converter has been replacedthree times by the dealer and when out again dealer wouldn't replace it .
Grease seals replaced. *sd
Clutch replaced. *sd
Fluid leaked from clutch slave cylinder lined and vibrated along exhaust manifoldwhich resulted in a fire.
Seat belt failed.
Brakes failed, repaired, however still fail.
Abs, while driving and applying the brake pedal to the floor loss of effectiveness.tt
Abs: when making panic stop, have to push down hard on pedal to stop vehicle; causes extended stopping; could cause accident, making an emergncy stop.tt
Intermittently when the brakes are applied the pedal goes to the floor,resulting in extended stopping distances.the dealer has replacedthe master cylinder/ booster pump/brake booster, front calipers and brake shoes .
When driving in heavy traffic and continue use of abs brakes, had complete loss of brake effectiveness.tt
Brake linings replaced. *sd
Brake system failure.tt
Front brakes replaced. *sd
Eclip missing from truck, causing accident/injuries/fatality.
When apply the brake pedal fades going to the floor .tt
Brakes overheated/failed. *sd
When applying the brakes, the brake pedal went clearly to the floor. Had to use the emergency brake to stop truck.
Brakes pedal want to the floor and there are no brakes.tt
Brakes overheated due to engine heat on unshielded brake line caused brakes to overheat and become inoperable.
Consumer was driving coming down a mountain the brake failed .ttconsumer states that vehicle needs a heat shield and insulation on brake hoses, a recall has been issued on some ford 350's because of brake and fire problems, however this unit was not included.
Intermittently when the brakes are applied the pedal goes to the floor,resulting in extended stopping distances.the dealer has replacedthe master cylinder/ booster pump/brake booster, front calipers and brake shoes .
Brake calipers broke. *sd
Brake shoes replaced. *sd
The defectivebrake rotor cracked in half 9 times in 80,000 miles which caused the braking system to malfunction.dealer cannot determine problem. Rotors have cracked nine times.
Master cylinder replaced. *sd
Power brake pump replaced. *sd
Intermittently when the brakes are applied the pedal goes to the floor,resulting in extended stopping distances.the dealer has replacedthe master cylinder/ booster pump/brake booster, front calipers and brake shoes .
Outer tie rod end replaced. 8sd
Power door lock cylinders replaced. *sd
Front end shakes. *sd
Vehicle intermittently vibrates.*aw
Wheel bearing replaced. *sd
This particular tire exploded @ about 60 mphon my truck .i had a 5th wheel trailer on behind at the time . It caused 1150.00 dollars damage to the truck. This is the 7th or eighth tire of the same brand &type that i had go bad. The others had the belts come loose and start viberating. I would take them back to a sears store and they would give me an adjustment and charge me75% of a new tire and put the same type back on. I would question them about the safty of the tire& they would just shake their heads.the first two tires were bought in farmington nm. On the28th of july 1998.the last two werebought the 19 of oct.1999 . Two more were removedthe6th of sept. 2000 but were replaced with different type . Iwas told the quit making it in my size. I still have three in my posession . One is blown and they want me to send it to pirelli for evauation. Sears wantsto pass the buck to pirelli. It is my contention the tires are diffenetlydangerous to the public. I was very lucky to have been able to bring my truck under control .i might add that these tires that have lost their belts have been on all for corners of the truck when they went bad. Thank you for your time. (dot number: chor524tiresize: 235 85 r16)
Owner cannot find information on recall number 91v146000.
Windshield wiper motor replaced. *sd
Read more
