We found the following complaints for FORD F-250 SD (1995)
Read complaints for FORD F-250 SD (1995)
Wiring harness caught fire do to manufacturing defect on speed control . No one has attempted to resolve this matter.
Truck was parked in back of my driveway and had been there for two weeks. The truck spontaneously caught on fire. A neighbor called me at 3 am or so to tell me my truck was on fireand by the time i went to go out with a fire extinguisher and try to put it out the engine compartment and the cab were fully on fire. My fire extinguisher did no good fighting this fire. The fire dept pulled up because my wife had called them and they took 20 min to put the fire out. The tires were partly melted the engine compartment and cab are gone(burned) and the back of the truck bed is not touched or even the paint burnt off.
Truck was parked in back of my driveway and had been there for two weeks. The truck spontaneously caught on fire. A neighbor called me at 3 am or so to tell me my truck was on fireand by the time i went to go out with a fire extinguisher and try to put it out the engine compartment and the cab were fully on fire. My fire extinguisher did no good fighting this fire. The fire dept pulled up because my wife had called them and they took 20 min to put the fire out. The tires were partly melted the engine compartment and cab are gone(burned) and the back of the truck bed is not touched or even the paint burnt off.
Cps went bad on my 1995 f-250 ford powerstroke engine.
The cam positioning sensor has failed twice on a 1995 ford f250 turbo diesel. Engine stalled in traffic lane on a narrow mountain highway.part replaced twice.why aren't the 1995 ford recalled under ford recall no. 07s57 ?
The contact owns a 1995 ford f-250 sd. The contact stated that a strong odor of fuel was coming from the vehicle. The vehicle was taken to a local mechanic, who examined the vehicle and located the failure at the front and rear fuel straps and fuel tanks. The vehicle had not been repaired. The failure mileage was 90,000 and the current mileage was 100,000. Updated 9/16/11 the consumer stated both gas tank were rusted as well as the front and rear straps.updated 11/02/11
On march 1999, an independent shop replaced all four bolts which held the axle bracket.the dealership replaced the bolts in december.on july 2002, once again all four bolts which held the axle were replaced.on july 2003, an independent shop replaced the same four bolts. Dealership was notified again.
A small brake fluid leak had been noticed around a sensor on the master cylinder but problem was put off as a minor problem. Truck was sitting approx. 5 minutes after driving, after walking out of store saw that the truck was dripping fluid that was on fire from the drivers side under the hood (brake reservoir) was able to put fire out, but did end up damaging master cylinder, power distribution box, andassorted wires and hoses.
Severe corrosion of brake lines that connect calipers and cylinders to tee fittings results in the rupture of the metal lines and results in the complete and immediate loss of the normal brake system.the latest failure is the brake line that connects master cyclinder to proportioning valve.i have replaced the forward and rear brake lines 3 (three) times since purchasing the truck in 1995.the loss of the vehicle's brake system isa severe safety hazard.
Truck was parked in back of my driveway and had been there for two weeks. The truck spontaneously caught on fire. A neighbor called me at 3 am or so to tell me my truck was on fireand by the time i went to go out with a fire extinguisher and try to put it out the engine compartment and the cab were fully on fire. My fire extinguisher did no good fighting this fire. The fire dept pulled up because my wife had called them and they took 20 min to put the fire out. The tires were partly melted the engine compartment and cab are gone(burned) and the back of the truck bed is not touched or even the paint burnt off.
I have a 1995 ford f-250 super cab 4x4 on many instances i have been driving down the road and hit a minor bump and my truck begins to violently shake so bad i have to pull over.ford has told me to get an alignment and that will fix the problem, i did and the problem still exists on doing some research i have found out that the problem seems to be a factory defect on a vast range of years.ford needs to fix this problem.
A small brake fluid leak had been noticed around a sensor on the master cylinder but problem was put off as a minor problem. Truck was sitting approx. 5 minutes after driving, after walking out of store saw that the truck was dripping fluid that was on fire from the drivers side under the hood (brake reservoir) was able to put fire out, but did end up damaging master cylinder, power distribution box, andassorted wires and hoses.
Read more
