We found the following complaints for DAEWOO NUBIRA (1999)
Read complaints for DAEWOO NUBIRA (1999)
Vehicle was involved in a frontal collision at 25mph, and the airbags did not deploy. Dealer and manufacturer have been notified.
Dt*:the contact stated while driving 55 mph on normal road conditions, the engine light illuminated.the vehicle was taken to the dealership who determined the crankshaft position center activated the check engine light.a recall letter was received however the dealer did not perform the recall remedy. Although the vehicle's vin was included in the recall the camshaft lot range was out of scope.
While driving 45 mph consumer noticed smoke coming from underhood. Pulled over and sawengine compartment on fire. Was able to put fire out. At this time consumerwas waiting to hear from daewoo. Amount of damage unknown.
The consumer was unable to have the cam shaft position (cmp) sensor recall 04v357000 performed because there was no dealership in the state.
Consumer receivedrecall notice 04v357000 concerning cam shaft position sensordealer was not in operation.
The consumer received a recall notice(0v4357000)for the camshaft position. Sensor.there was no dealer available in the area to perform the recall.
Dealership refused to honorcam shaft positionsensor recall 04v357000because they were not getting reimbursed by the manufacturer for the recall parts and labor.
Consumer states that she received a recall notice from daewoo.but when she took her vehicle to the dealer they refused to do the recall because they said that her camshaft sensor number did not match on their list.she states she even offered to pay for the service, but they flat out refused.she states that the dealer's name is bob brockland, pontiac, gmc inc.1699 pontiac drive, cahokia, ill 62202618 332 2277.she states they told her that they would only inspect her vehicle.consumer went to another repair facility whre they removed and replaced the camshaft position sensor, timing belt, and spark plug wires.
Consumer received recall 04v357000 concerning cam shaft position sensor. Consumer cannot find a dealership nor contact the number provided on the recall letter for daewoo customer service.
Recall 04v357000 concerning cam shaft position sensor.dealer kept insisting no parts were available.
1999 daewoo nubira will not start. Consumer would like manufacturer to pay for recall repairs and bad parts.
Consumer received recall 0v4357000 concerning cam shaft position sensor.dealer was not in operation.
The check engine light was on.the dealer kept telling the consumer they did not have any parts. Cam shaft sensorrecall 04v357000.the engine stalled while sitting at a red light.
Consumer received a recall 04v357000 concerning cam shaft position sensor.dealer was not in operation.
1999 daewoo nubira shaft sensor malfunctioned while driving at 60 mph.*mr
Consumer is not satisfied with the reimbursement received for recall repairs performed on the 1999 daewoo nubira. *mr the consumer requested reimbursement.recall campaign#'s 04v357000 and 04v394000.the engine light had come on many times, there was a broken time belt and 6 bent valves and the gas pedal was loose. *sc
Vehicle has a smell of smoke. There were no dealers in the area to repair the camshaft sensor recall 04v357000.
Consumer received recall 0v4357000 concerning cam shaft position sensor.dealer was not in operation.
Recall 04v357000 concerning cam shaft position sensor. Check engine light illuminated afterrecall repairs were done.
Consumer received nhtsa recall 04v357000 regardingcam shaft position sensor. No dealership wasavailable. The phone provided in the letter was not working.
Consumer received a recall noticed(04v3570000)cam shaft position (cmp) sensor dealer was not i operation.
Consumer received recall 0v4357000 concerning cam shaft position sensor. Dealer was not in operation.
The consumer received, nhtsa recall campaign letter #04v357000 regarding the camshaft position sensor.however, the vehicle caught on fire on june 2003,there was no dealership available in the area.the vehicle door locks worked erratically.the door locks would not disengage when the consumer vehicle caught on fire, trapping him and his kids inside the vehicle.
The check engine light comes on intermittently. There are no dealers to repair the cam shaft position sensor recall04v357000.
Consumer received recall 04v357000 concerning cam shaft sensor.dealer was not in operation.
Consumer received a recall 0v4357000 conce cam shaft position sensor.dealer was not in operation.
Consumer received, nhtsa recall #04v357000 regarding crank shaft position sensor. No dealership neither parts were available in the area of new jersey , the phoneprovided in the letter was not working.
Consumer received recall 04v357000 concerning cam shaft position sensor and went to the nearest daewoo dealership in the region. That dealership will not do warranty or recallrepair work.
Ferrero daewoo of loveland.consumer receivedrecall 04v357000 regardingcrank shaft position sensor.dealership didn't have the partsavailable, and indicated to the consumer the manufacturer went out of business.address:2600 north lincoln avenue,loveveland , co 80538, phone:800-660-3305. Consumer was told that the vehicle could catch on fire so it is not being driven.*tc
Consumer receivedrecall 0v4357000 concerningcam shaft position sensor. Dealer was not in operation.
After receiving the recall for the camshaft sensor.the consumer will be responsible for the repairs.. Nhtsa recall04v357000.
While driving at any speed engine warning light illuminated. Dealership will be notified.
Nhtsa recall: 04v357000 subject: camshaft position sensor. The consumer was unable to locate a dealer in the area to honor the recall. Please provide further details.
The consumer was unable to have the cam shaft position (cmp) sensor recall 04v357000 performed because there isn't any dealerships still in business in their state.
The consumer received a recall call notice(0v4357000) for the camshaft position sensor.the dealer was not in operation.
Dt*: the contact stated a recall letter was received in may 2006 regarding nhtsa campaign id # 04v357000; engine and engine cooling. The contact located a dealership however, the dealer refused to perform the recall because the contact did not purchase the vehicle there. The check engine light is illuminated in the vehicle.the vehicle is a 1999 nubiradaewoo.updated 7/7/2006 -
There was no dealer or service center to repair the cam shaft censor.a dealer was found, however they stated they do not honor recalls. Recall #04v357000
Dt*: the contact stated upon receiving a recall letter pertaining to the camshaft module valve the manufacturer was called. The manufacturer sent a follow up letter stating that reimbursement would be made for any parts and labor performed for the recall on the vehicle.the contact express distrust that daewoo, who filed for bankruptcy, would hold true to this agreement.the vehicle has not been serviced.updated 8/14/2006 -
Consumer received nhtsa recall 04v357000 regardingcrank shaft position sensor. No dealership was available, the phoneprovided in the letter was not working.
Consumer received nhtsa recall 04v357000 concerningcam shaft position sensor. After having the cam shaft position sensor replacedthe check engine light appeared on the dashboard. Vehicle was taken back to the dealer for inspection, andmechanic determined that the cam shaft position sensor needed to be replaced again.
Check engine light appeared on the dashboard and remained on. Consumer received nhtsa recall 04v357000 on the cam shaft position sensor.however, consumer was unable to locate a dealership in the area.
Recall 04v357000 was issued for the cam shaft position sensor.consumer statesdealer refused to repair the vehicle at no cost under the recall because the vehicle part serial number was not included.however, the vin was part of recall.
Engine warning sign sometimes kept coming and going or blinking. Went to a mechanic and he thought it wasn't the problem of the engine since there was no record in the memory in the car. After a few weeks later, car stopped on the road. Towed the car to a mechanic and discovered two pistons were broken and he recommended to replace the engine to another one with new parts that belong to the engine. It cost me $2721.01 total to fix.
Consumer complaint concerning the 1999 nubira camshaft sensor recall.the consumer took the vehicle to the dealer and the camshaft sensor was replaced.the consumer was charged for the repair and request reimbursement.
Dt*:the contact stated that prior to receiving a recall letter pertaining to the engine and engine cooling: camshaft censor - campaign id # 04v357000,the contact had the timing belt repaired on two occasions as well as the engine installed by an independent mechanic.the contact asked the mechanic if the timing belt and engine malfunction could have been caused by a defect.the mechanic denied that it could have been the case. When the dealer was contacted and asked the same question the dealer determined the camshaft censor could absolutely cause the timing belt to freeze up and affect the engine as well.the dealer confirmed that vehicle was included in the recall recommended the vehicle to be towed to the dealer for the recall work.the model was a nubira.
While driving, engine check light will come on.consumer has to take vehicle to dealer and they will reset the light. This has happened twice.dealer replaced the cam sensor.
Intermittently between 40 &45 mphvehicle goes into a lock up mode, where the rpm's drop at least a 1000 rmps, resulting in loss of power for a moment.dealer has inspectedvehicle.
At a mere 57,323 miles on my car the timing belt snapped in the middle of my drive home from wwork, which left me stranded.
Timing chainwent out.told when this happens on a daewoo it usually damages the valves. Total cost $1400.00 with 1 month to get parts.search many gm/chevy places which now service the daewoo.only have 71240 miles on car.got it at 51200 and put around 20k on it.
Dt*:the contact stated while driving 55 mph on normal road conditions, the engine light illuminated.the vehicle was taken to the dealership who determined the crankshaft position center activated the check engine light.a recall letter was received however the dealer did not perform the recall remedy. Although the vehicle's vin was included in the recall the camshaft lot range was out of scope.
The consumer received, nhtsa recall campaign letter #04v357000 regarding the camshaft position sensor.however, the vehicle caught on fire on june 2003,there was no dealership available in the area.the vehicle door locks worked erratically.the door locks would not disengage when the consumer vehicle caught on fire, trapping him and his kids inside the vehicle.
Daewoo nubira's brake got stuck and lost contol of the vehicle. Emergency brake was frozen and the car does not go in reverse.
Daewoo nubira's brake got stuck and lost contol of the vehicle. Emergency brake was frozen and the car does not go in reverse.
I own a 1999 daewoo nubira.for the last year or so it does what the toyotas are doing.more so in the summer months.this past saturday when i was stopped it started revving in drive, i put it in neutral, it revved higher, i put it in park and it settled down.this morning at 2 am. In cool weather, it even was revving in park, i had to turn it off.what should i do. Have you had other complaints?thank you
While driving and upon depressingbrake pedal attempting to make a gradual stop, pedal traveled to the floorboard, causing extended stopping distance. Consumer has contacteddealer, dealer was unable to determine the cause of the problem.the brake failed to engage still after repair was done.
Daewoo nubira's brake got stuck and lost contol of the vehicle. Emergency brake was frozen and the car does not go in reverse.
Consumer receivedrecall 02v257001 concerningbrake hose.dealer was not in operation.
Automatic door locks locked by themself.
Automatic door locks locked by themself.
Vehicle jerks to the left when taking foot off the accelerator.front end has made a squeaking noise for 2 years- daewoo mechanic claims there is nothing wrong.had to replace all rear brakes and rotors and pads in front after only 36000 miles.dt
While driving and without warning, the control arm bushings started to malfunction. Problem has reoccurred.dealership was having a difficult time locating parts. Consumer also stated that the dealership found that it was a design flaw, and the vehicle was unsafe to drive because it was uncontrollable.*scc
The control arm made a cracking noise when driving, there was a recall regarding the issue, however the vehicle was not included.
The lower control arm has problems. Dealer has not been contacted. Tswithout warning the control arm bushings wore out.this happened when accelerating or engaging in mild turns.parts have been difficult to obtain.*jg
When changing lanes steering wheel vibrated. The tires were wearing unevenly.vehicle was driven to a dealership,who indicated that this occurred because the lower control arms were defective, and needed to be replaced. The parts were replaced, but the failure recurred.
Tire was original on the left rear mount of the car, tire went flat, dealer said they would replace the tire, but they didn't, dealer plug the tire. Put it on the left front and the tire blow out, the day was sunny and traffic was not heavy, the tire had good tread.
Car quit in midst of driving.i thought it stalled.towed to shop to find out the timing belt broke.this car had 44813 miles on it when this happened, mechanic said this is unheard of and dug to find the reason.water pump was leaking internally, caused the timing gear to rust and freeze which caused the belt to break.this caused engine problems and had to have the head resurfaced.this problem caused major problems and expense ($2245.17).owner of the shop said that a timing belt doesn't even have maintenance (look at it) until a vehicle has 60,000 miles on it.there was no way to know that the water pump had a problem.
The dealer reports they have 6 with the same problem.car swerves on acceleration.
I have already reported to the dealership of problems with decreasing speed, acceleration and cruise control of the daewoo nubira.i have a standard shift vehicle with five gears.when i get the car up to 60 mph or more and let up on the gas, the car jerks forward and back!!i had the dealership take a look at this problem.they compared my car versus a newer model (with an automatic transmission) and they found the same problems that i faced.they used the cruise control and found that the car has a jerking action while trying to maintain its cruising speed.they informed me that they filled out a "tech report" and that in future models they will work on the problem.i really do like my car, but i cannot stand the jerking action.i don't know if others have reported this problem or if it is just a couple of nubiras that experience these problems.either way, i consider this a defect in the cruise control and acceleration/decrease of speed.thank you for taking this request and, if possible, could you inform me if there has been any other problems such as this reported.thank you.- brian p. Blythin
Consumer is not satisfied with the reimbursement received for recall repairs performed on the 1999 daewoo nubira. *mr the consumer requested reimbursement.recall campaign#'s 04v357000 and 04v394000.the engine light had come on many times, there was a broken time belt and 6 bent valves and the gas pedal was loose. *sc
Read more
