We found the following complaints for CHRYSLER 300C (2010)
Read complaints for CHRYSLER 300C (2010)
2 issues: 1)while driving, vehicle frequently shows no air pressure in front driver side tire sensor, happens frequently2) while starting, vehicle will start and run for approx 2-3 seconds then engine will shut off, issue 2 typically does not repeat after turning off vehicle then restarting. This issue occurred more often when starting vehicle after being briefly turned off
On or about february 10, 2017, i brought my chrysler 300c to orr chrysler ' dodge ' jeep ' ram located at 900 truman baker drive, searcy, ar 72143 via a tow truck because of a dead battery that had failed due to a faulty, defective alternator.after my father spoke with tommy, the service manager, my car was repaired; however, he and i were under the impression that the car would be repaired through a safety recall notice 14v-634 (aka p60) that had been issued for chrysler 300 cars experiencing similar issues.
Problems with the w i n module. Or wcm. Push start passive entry non-functional including remote start non-functional. W i n module malfunction. Unrecognized key transmission failure. Safety issue.
The car shuts off while driving.this has happened to me at least 5 times in the past month so far usually in the middle of a turn.i have to put the car in park and turn the key in order to start it up again.it starts up and i'm on my way again.the issue is there is no warning like the car slowing down or vibrating or a dashboard warning light before it shuts down.i'm afraid the driver behind me will run in to me because of this.i've had a diagnostic test done today and the repair shop could not tell me what is wrong because they see no history of any codes coming up.they would need to see it happen.that would be hard to do.
2 issues: 1)while driving, vehicle frequently shows no air pressure in front driver side tire sensor, happens frequently2) while starting, vehicle will start and run for approx 2-3 seconds then engine will shut off, issue 2 typically does not repeat after turning off vehicle then restarting. This issue occurred more often when starting vehicle after being briefly turned off
Antilock brake system (abs) module malfunctioned.brakes function is being compromised and warning lamps were activated.vehicle/component was inspected by the dealership and the abs module was replaced at owner's cost.there is similar abs module recalls (refer to fca safety recall r61/nhtsa 15v-675).
For the past two months while attempting to accelerate, my rpm will jump to over 3 while barely pressing on the gas. This issue tends to happen more when i slow down (but not completely stop, like at a changing light) and attempt to speed back up. My car doesn't accelerate very fast but the rpm will be very high. Also, while on the highway, going a constant speed my rpm will jump up and down. I've attempted to use my autostick to get the rpm to drop back down and it only helps occasionally. I've had spark plugs replaced, a new battery, a transmission flush, wires replaced for the throttle body (they were broken/burnt), my car said it had the wrong oil in it, so i got another oil change, i've had the transmission flashed twice. I've had 5 different people/shops look at my car (including the dealership) and none of them can figure out what's causing it, all repairs have totaled over the last two months since having this issue, roughly $1,500. The issue is still happening and this is my second chrysler 300c.
2 issues: 1)while driving, vehicle frequently shows no air pressure in front driver side tire sensor, happens frequently2) while starting, vehicle will start and run for approx 2-3 seconds then engine will shut off, issue 2 typically does not repeat after turning off vehicle then restarting. This issue occurred more often when starting vehicle after being briefly turned off
Read more
