Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE




We found the following complaints for CHEVROLET G20 (1992)

Read complaints for CHEVROLET G20 (1992)


Looked in rear mirror, noticed smoke , looked under van saw flames, no machanical problems, damage to van incluedes interior front half of van

The consumer has been experiencing problems with automatic transmission.vehicle bounces and sways side to side during any speed.in addition the seat belts aren't long enough to secure their driver.also, the fuses in the electrical system started failing.

Replaced leaking seal/oil pan gasket/heater core. Also replaced serpentine belt.

Replaced leaking seal/oil pan gasket/heater core. Also replaced serpentine belt.

Gas expulsion after filling tank.

We have had an ongoing problem with the fuel filler "neck" on this vehicle.when you fill the vehicle up with fuel, once it is almost full, the gasoline tank "belches" (for lack of a better term) and fuel is expelled from the tank all over the person filling the vehicle (unless you stand appx. 2' away from the gas pump nozzle).we have talked to owner's of similar vehicles (this is a full size chevy conversion van) and all of them have the same problem.this is a very dangerous problem.fuel literally erupting from the filler nozzle can easily spray anyone standing nearby and can cause caustic burns to human flesh.please investigate this serious problem!!both chevrolet & gmc manufactured this vehicle from 1971 - 1996 and most, if not all, probably have the same problem.thank you!

Front oil pump in auto-transmission has failed interrupting response of acceleration when needed. Please describe details.tt

The consumer has been experiencing problems with automatic transmission.vehicle bounces and sways side to side during any speed.in addition the seat belts aren't long enough to secure their driver.also, the fuses in the electrical system started failing.

Automatic transmission failure, torque converter has been replaced five times, leaking transmission fluid.ttfirst the transmission was repaired due to vibration. Then the torque converter was replaced. The transmission started leaking and the pump bushing and new torque convertor were replaced. Again the transmission began vibrating and leaking. The problem still exists after tires were replaced as possible cause. Cruise control failed.drive shaft was leaking

Torque converter failed causing vibration. Mjs

Replaced leaking seal/oil pan gasket/heater core. Also replaced serpentine belt.

Automatic transmission failure, torque converter has been replaced five times, leaking transmission fluid.ttfirst the transmission was repaired due to vibration. Then the torque converter was replaced. The transmission started leaking and the pump bushing and new torque convertor were replaced. Again the transmission began vibrating and leaking. The problem still exists after tires were replaced as possible cause. Cruise control failed.drive shaft was leaking

The consumer has been experiencing problems with automatic transmission.vehicle bounces and sways side to side during any speed.in addition the seat belts aren't long enough to secure their driver.also, the fuses in the electrical system started failing.

Seat belts on both front seats are poorly placed and cause the seat belt to lay across the neck of the driver and front seat passenger. This has also caused excessive wear on the belts to the point of being frayed. In an accident, it appears that severe neck injury would occur due to their placement. This is a mark iii conversion van so i am not sure if the fault lies with the manufacturer or the conversion company.

Passenger and driver recline seat bolts broke, cause the seat fall backwards.tt

Passenger and driver recline seat bolts broke, cause the seat fall backwards.tt

The contact owns a 1992 chevrolet g20. The contact stated that the brakes failed and caused the contact to crash into the rear of another vehicle. The contact was able to drive the vehicle to a mechanic and was told that the support for the brake line was rusted and the pressure caused the brake line to rupture. The vehicle was repaired. The vin was not available. The failure and current mileages were 171,000. Updated 09/27/11*ljupdated 2/23/12

Abs, when applying brakes on wet surface front brakes lockup.tt

Abs system not working properly when brakes are applied they do not catch right away.tt

While applying brakes there was no pressure on first attempt, then released pedal and tried again and pressure had returned. Cause unknown.

When brakes are applied steering wheel shimmies.

No summary provided by consumer

Drivers side door is falling off.please describe.tt

The consumer has been experiencing problems with automatic transmission.vehicle bounces and sways side to side during any speed.in addition the seat belts aren't long enough to secure their driver.also, the fuses in the electrical system started failing.

Front suspension rusted through, causing the driver's side front wheel to collapse, andcould have caused loss of control.please provide further information.

While driving will go open throttle position or close position, causing to stall or accelerate.tt

Automatic transmission failure, torque converter has been replaced five times, leaking transmission fluid.ttfirst the transmission was repaired due to vibration. Then the torque converter was replaced. The transmission started leaking and the pump bushing and new torque convertor were replaced. Again the transmission began vibrating and leaking. The problem still exists after tires were replaced as possible cause. Cruise control failed.drive shaft was leaking

Replaced leaking seal/oil pan gasket/heater core. Also replaced serpentine belt.

No summary provided by consumer




Read more




© 2024 All rights reserved