We found the following complaints for CHEVROLET CAMARO (1987)
Read complaints for CHEVROLET CAMARO (1987)
Purchase car new in 1987 car stalls .tt
Car was sitting still running in neturalwhen it exploded in to flames with" no warning signs" totally destroyed car passanger side is burned the most![passengers "mother and son " managed to excape the burning car inferno }this1987 z-28 camaro inferno took place in wal-mart parking lot.
1987 chevrolet camero caught on fire. *mr *sc
When driving after 2 or 3 minutes the car starts to pause, as if it is stalling. Dealer has not seen.
Catalytic converter rattles.it sounds as if engine will fall out.
While trying to change a flat tire the jack bent and collapsed under the weight of the empty car. Mjs
After lifting up the vehicle, the jack itself bent and collapsed under the weight of the vehicle, creating a very distressing and dangerous situation.
Rear parking brake failed, resulting in an accident/injuries.
Driver side seatbelt buckle broke, there is no contact withretractor.consumer notifieddealership.
The contact's girlfriend owns a 1987 chevrolet camaro. The contact stated that the driver's side seat belt had become defective. Upon research, the contact discovered that there was a recall that had been placed on the vehicle for the seat belts however, the recall number was unknown. The contact took the vehicle to platinum chevrolet (3001 corby ave, santa rosa, ca 95407) where he informed the dealer of the seat belt recall. The contact was then informed that they could not offer any assistance due to the database not having information on a vehicle of that age. The manufacturer was then notified of the issue and a case was filed. The manufacturer then notified the contact that due to the age of the vehicle and the inability to locate the recall, they denied his recall claim. The vehicle had yet to be repaired. The failure mileage 49,858.
Driver's side seatbelt broke. Dealership told her that that part wasn't available.
Neither seat belt will lock. Passengers use to lock but could not get out of the seat belt and pulled on it and it fell apart.if i was in a accident i would not be protected. *la
The driver's seat belt failed to latch after recall was performed,because the metal guide was missing.
No summary listed for above vehicle.
Both driver's and passenger's side seat belt buckles are inoperativedue to the buckle assembly having a crack. Also the red plastic button is stuck. Consumer has contacted the dealer. There also a recall listed for the same problem recall 90v105000.
Front passenger's and driver's plastic component in the seatbelt buckle has disintegrated.consumer was not able to use seat belts.
Consumer received two recall letters for seatbelts. Red plastic buttons werebrittle and discolored.consumer felt that buckle may not latch in an accident because ofcondition of latches.
The drivers side seatbelt buckle failed to latch, did not restrain occupant in an accident, resulting in an injury prior to recall (90v-105).
Theseat belt buckle experienced the same defect as stated in recall 90 v 105 000 however, the vehicle identification number was not included in the recall.
The left seat belt buckle comes unlatched all the time, the right one has just broken, making it totally useless.i took my vehicle in for the original recall, and was told that the recall was now closed.i offered to pay for the repairs, but was told that chevrolet no longer manufactures the seatbelt buckles that are needed.they told me to go to a junkyard and get another set.i am not willing to do that, knowing that the seatbelts are faulty to begin with.
Equipped w/v8 engine brake line runs next to exhaust manifold on drivers side and abrasion causes loss of fluid w/brakes failing. Please describe details.tt
(tilt steering) steeringwheel very loose. Hard to steer in curves and on turns. Steering wheel move about a inch or 2 when trying to steer. Feels like the steering is going to fall off, have had it checked and the mechanic said that the bolts on the tilt are falling out. That there should be a recall on this problem. *la
Steering column failure, bolts are very loose, causing movement of the steering wheel.
Steering column loose.
The four bolts holding the lower tilt-wheel pivot became loose, causing the steering wheel to flop overto the side, making it difficult to drive.
Tilt steering wheel moves excessive due to bolt either coming off or busted. Please describe details.tt
Hood struts failed to keep hood in the open position.
I was at the entrance gate to the parking lot where i was working, at the time, about to put my card in the card reader, to open the gate. The car was in drive and my foot on the brake. The engine started to race without warning and i had to stand on the brake pedal with both feet before i finally got the ignition key turned off. I restarted the engine, in park, and the engine took off again. I shut it off, played around with the cruise control buttons (which were in the off position) and restarted the car. This time it was fine. The car never did it again.the vehicle was a 1987 chevy camaro ls.
Read more