We found the following complaints for CHEVROLET C35 (1993)
Read complaints for CHEVROLET C35 (1993)
Has problem since 1994 with electrical shorts such as the radio and electrical wiring.tt
Cast idler pulley fails w/serpentine belt design. Component replaced (3) times losing power steering immediately. Ttconsumer states that tensioner fails in the middle of casting, this has happened twice, seems to be a common problem as dealers in two different states were used to but replacement part, manufacturer was contacted but consumer was told there is nothing they can do .
Has problem since 1994 with electrical shorts such as the radio and electrical wiring.tt
Truck was parked on the street and truck caught on fire .ttthe fire depatment investigatedthe cause of the fire and determined that it was caused by the rear dome light.
Transmission won't shift into overdrive sometimes.
The hydraulic slave cylinder has blown, causing the vehicle to be inoperable. The owner has replaced the clyinder three times prior to this incident.the dealer will be notified.
Differential fluid leak.
The bolts that hold secure drivers seat broke off.tt
Total loss of the rear brakes, equipped with rear abs brakes.
Total loss of the rear brakes, equipped with rear abs brakes.
At 10,000 miles brake heats up the front rotor and warp disc dealer repair this problem four times can't find problem .tt
Cast idler pulley fails w/serpentine belt design. Component replaced (3) times losing power steering immediately. Please describe details.tt
Cracks developed behind the cab on passenger side, hydraulics went out on truck because it pulled away from the frame.tt
Frame cracked on right side near the cab area.tt
Sub-members and frame broke in half, broke while driving,
Frame broke on the flat bed, railway drilled holes in the frames, resulting in breakage.
While driving car frame broke in half starting behind the cab of the vehicle.tt
We own a 1993 chevrolet 1 ton dually pickup truck, and to this date we are still paying on a loan for this truck. While washing the truck 2 weeks ago, i discovered that thepickup box had broken loose from the frame of the truck. Not knowing at this point exactly what had happened, i got the truck to a hoist and did further investigation, only to find that the frameword under the pickup box, which is pia to the pickup box, have broken loose. These are the crossmembers that attach the box to the frame, using a j clip in the crossmember, and a bolt from the frame to the crossmember. My complaint is what holds this box on? it does not relie on any nuts and bolts to hold the box on, but relies on spot welds.because the bed is not bolted on, the crossmember is. I use this truck as a hauler for my camper, and interesting enough, the rv industry sells the hold-downs that attach a pickup camper to the box. At this point, the only thing holding the camper on the truck is those same spot welds, because the nuts and bolts only hold the crossmember, not the actual box. We think this problem is quite out of the ordinary, and truly thought that general motors would think so to and fix our pickup truck. While talking chevrolet customer service, the service rep. Agreed he had never heard of this problem before, as did the body shop manager at the dealership we took it to. The claim was denied from gm rep. Due to mileage. We feel that this is not a warranty claim, for it should have no bearing on the mileage, but be considered a safety issue. We cannot bear the thought of what would had happened if this box had broke loose while we were traveling on the road. What a disaster it would havebeen.iwork for a automotive prototype engineering firm , i am not an engineer but a mechanic, but i see new ideas and the automotive industry trying to cost cut vehicles all the time, and i feel that the constuction of the box is not safe.
The frame is cracked.please describe.tt
The frame completely broke on the right hand side rust was found on frame.tt
Pe00 020; was traveling about 65mph onhighway and heard a banging noise,tread from tire was banging againstvehicle,andvehicle started shaking. Driver lost control, andvehicle went into an enbankment.right front tire trend separated, andvehicle came to a complete stop. Tire is tbc inc235-85r16. Consumer stated that he will contact chevrolet.he wasn't hurt.
Purchased truck new and the mirrors move out of place, dealer tightened them, still having the same problem, almost caused an accident. Please describe .
Vehicles rear studs on wheels broke inside the hub on drivers side rear due to metal fatigue.tt
Read more
