Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE
Use this form now and GET 20% DISCOUNT for CarVertical reports!




We found the following complaints for CHEVROLET BLAZER (1990)

Read complaints for CHEVROLET BLAZER (1990)


Consumer pulledvehicle in driveway and there was black smoke coming from underneathhood and the dashboard.fire department was called out to putfire out.

Electric short. *sd

While driving heard things under the hood making noise. Pulled over and opened hood, and there was a fire underneath.called the police, but the fire was then put out.

While vehicle was parked it caught on fire under the dash due to an electrical short.

Consumer states that gmc installed a motor intruck. Whenconsumer went to start vehicle, truck burst into flames, injurying several people.

Oil filter adapter needed due to leak. *sd

Gmc installed a motor. Upon starting vehicle, it burst into flames, injuring several people.

Possible engine failure resulted in engine fire (ohio traffic crash report). *mjs

While driving the vehicle began to experience engine trouble, the driver pulled the vehicle over, the vehicle started smoking then became engulfed in flames (ohio traffic crash report).nlm

Vehicle jumped out of gear while on a slight grade in a parking lot.tt

Transmission fluid spewed out vent/filler tube onto manifold, causing fire.

Right constant velocity joint failed. *sd

The driver's side automatic seat belt mechanism will not release the seat belt when trying to put on the seat belt.

Passengerside and driver's side seatbelt mounting rusted out. While trying to fasten seatbelt entire belt popped out/.loosened consumercan't fasten seatbelt.

The passenger's and driver's side seat belt anchorage rusted,causing the seat belt to become inoperative.

Seatbelt buckle jammed into seat handle recess and cannot extracate; believe this is design defect, buckle should be larger to avoid fitting into seat lock recess.cannot use safety belt, cannot raise/lower seat.

Seat belt retractor jammed.

The front seat track came apart front left corner .tt

When applying brakes, noticed seats move due to looseness. The bolts were tightened.checked underneath & noticed mounting plate metal forseat was rusty & had corroded away. Have not taken to dealer.

Significant damage to seats in light impact collision. (attorney for client) *dh

Consumer was driving approx. 15 mph when he pressed the brakes to slow down for vehicle in front making a turn, and the brakes failed.consumer crashed into the car in front of him, then he was hit from behind during the same crash. There was drizzles of rain at time of incident. Consumer has experienced brake failure more than five times.

Ongoing/intermittent problem with abs locking up while applying brake pedal. Dealer/manufacturer were not contacted.

When applyingbrakes pedal goes tofloor, causing extended stopping distance.please give any further details.

When applying the abs brakes, while going down a hill, the abs light came onand brakes failed to stop the vehicle, causing an accident.

While driving home in a heavy rain storm came to a stop at top of steep hill, getnly tepped the brakes, brakes failed to stop vehicle. Vehicle slid into the back of a truck, causing extensive damage.

Defective abs is causing loss of back brakes without warning. Dealer has replaced dump valves 5 times, defect is still reoccurring.

Abs: brakes completely worn out; pedal went to floor causing extended stopping; rotors/pads worn out; replaced five times.tt

Abs: brakes completely worn out; pedal went to floor causing extended stopping; rotors/pads worn out; replaced five times.tt

Abs: brakes completely worn out; pedal went to floor causing extended stopping; rotors/pads worn out; replaced five times.tt

Want to know if there are any recalls on this blazer.

Significant damage to rear bumper in light impact collision.

Vehicle developed severe driveability problems, includin gpulling and drifting to left and right. Also, premature tire wear.

Ball joint and control arms failed. *sd

Upper left and right ball joints failed. *sd

Excessive and irregular tire wear.

Consumer was traveling about 70mph there was a loud thumbing noise underneath the vehicle. Consumer lost control ofvehicle.tire tread was off,and vehicle was traveling on the rim.consumer's nine year olddaughter was thrown from the vehicle.

The paint on the hood and roof of vehicle has turned white and discolored. No safety defect listed in summary.

Paint is bubbling and peeling off, exposing primer underneath in various locations on the vehicle.

Sudden acceleration, causing accident.

Idler arm replaced. *sd

Rear defogger inoperative. *sd

Wiper switch causes computer board inside wiper motor to overheat. Stops the wipers in midstream.tt




Read more




© 2024 All rights reserved