We found the following complaints for BUICK CENTURY (1990)
Read complaints for BUICK CENTURY (1990)
Vehicle has trouble starting due to battery failure.
Every six months the electrical battery runs down,have to replace it .
Vehicle stalled due to failure of the alternator.
Alternator replaced. *sd
Intermittent stalling.
Spark plugs replaced. *sd
Vehicle not starting due to ecm failure.
Circuit breaker for seat in fuse compartment overheated, causing power seats and power door to be inoperative. Driver is unable to replace fuse because it was so hot, it burned. . consumer states when he touched the correct fuse he was burned leaving a blister on his finger and thumb, consumer states he discovered there was a recall, however the dealer knew of the campaign but could not find consumers vehicle in the system.
While driving, heard noise, within minutes, all power stopped, black smoke poured out from underhood, fire started coming from under vehicle, no warning.
Water pump replaced. *sd
Radiator cooling fan replaced.
Consumer states that while driving and without warning the engine blew and the vehicle started to smoke under the hood causing the consumer to pull over.dealer notified. Mr
Motor fell to ground while pulling out. Thisdamaged steering and car was out of control.
While driving down the roadall of sudden the vehicle just shut off when making a stop or slowing down.contacted dealer, and he was not able to find out what was wrong on the diagnosis machine.
Fan belt replaced. *sd
Exhaust system replaced due to corrosion. *sd
Rear tail light assembly failed twice.
Carburetor backfired starting a fire, the electrical fuel pump continues to pump fuel, causing the car tocompletely burn.
Carburetor backfired starting a fire, the electrical fuel pump continues to pump fuel, causing the car tocompletely burn.
Transmission slipping due to metal chips found in pan/fluid burned. *sd
During accident front bench seat latch failed causing the seat to collapse, right front passenger seat belt also became unlatched, resulting in injury.nlm
Recall on the seat belt denied due to wrong information (vin #) on the mail out .
Design flaw in seat belt that attaches to door, leaving occupant free to fall out of vehicle if door opens in accident. *dh
Seat belts do not function properly.
The drivers seat belt buckle sticks and you cannot get out. Please explain.tt
Seat belt; failure on the driver and passenger side seat belts, consumer was in a accident and the driver and passenger side seat belt did not lock.
Drivers side front lap/shoulder belt buckle separated will not latch properly.tt
The passengers and drivers seat belts have no tension. Please describe.
Driver's side front seat torn away from chassis; when applying brakes, seat not stable, rocks back and forth; could cause accident.tt
The seat is loose in the track on one side which causes the seat to slide when the brakes are applied.tt
Driver's side front seat tore away from chassis; when applying brakes, seat was not stable, rocked back and forth; could cause accident.tt
Failure of the driver side seat, the seat is reclined to the back position. The driver's side seat travels on rails back and foward, while drving a metal bracket on the left side, that anchored the seat to the floor broke in half, therefore making the seat as a whole tilt backward.
During accident front bench seat latch failed causing the seat to collapse, right front passenger seat belt also became unlatched, resulting in injury.nlm
The front driver's side split seat is coming loose from the floor. Has not seen dealer.
Front brakes make noise. *sd
Brakes failed several times.
Rear brake linings cracked. *sd
Problems with vehicle's steering.*mr stiffness in steering, sometimes consumer have to steer in neutral as it doesn't come back by itself. Sometimes it squeak while turning, no lock up has occurred yet. *ph
While driving on road noticed vehicle pulling a sharp left. Looked at the cradles, and the retainer washer broke/was rusted through.replaced it. Also, others needed to be replaced.in addition,rack & pinion steering assembly is connected to engine cradle frame and the steering shaft, dropped.this may cause erratic steering problems.
While driving on road noticed vehicle pulling a sharp left. Looked at the cradles, and the retainer washer broke/was rusted through.replaced it. Also, others needed to be replaced.in addition,rack & pinion steering assembly is connected to engine cradle frame and the steering shaft, dropped.this may cause erratic steering problems.
While driving down the highway, i noticed that the front of car lurched and the steering wheel position changed.pulled car to side and saw that part of frame was hanging down.took to dealer who said that the cradle bolt had pulled through the support and was hanging down.why wasn't my car on the recall campaign as the regal was?i am afraid that the other bolts will pull through and i will lose my directional steering ability.i have kept all defective parts for the nhtsa review.it appears that the metals fussed or migrated together.did buick use the two wrong metals in this area, causing this problem?is their an active campaign for the century? please feel free to contact me.
On wednesday 6/13/2002 my 1990 buick century lost steering control due to a failure in the cradle bolts.i could have been seriously injured.i have found the following recall which includes the 1990 buick regal, nhtsa recall no. 97v058/gm recall no. 97016. My vehicle is a 1990 buick century with 3300 v6 and is not listed in this recall.i believe the cradle bolt's in 1990 buick century's are also subject to failure, causing the same safety related issue motioned in this recall.my vehicle does have 202000 miles on it, but this is the kind of failure should never have happened. I believe buick should repair my vehicle at their cost. I have found two other complaint about the same problem. I tried to issued a complaint the hntsa on 6/21/2002 over the phone but it failed to get entered so here a try by email. Home email [email protected], work email [email protected], home phone 765-447-2782, work phone 765-429-1387.
The driver side hinge in the door had broken and fell off and the other hinges are cracked. The dealer said that it's the owner problem.tt
Hydraulic lift/shock fails sliding off and weak support. Please describe details.tt
Paint started peeling away since 1993 and has gottenprogressively worse.
Wheel alignment repair. *sd
Three tires replaced. *sd
Tread separated on tires.
None of the power windows would open or close. Vehicle was taken todealership.two broken wires were reconnected at owner's expense. Please provide any further information.
Read more
