We found the following complaints for BMW R 1200 ST (2005)
Read complaints for BMW R 1200 ST (2005)
I own a 2005 bmw r1200st motorcycle, it has 28,837 miles on it and the quick disconnects for the fuel tank are plastic and will/do break unexpectedly. Thus upon noticing this condition i proceeded to replace the plastic with steel parts where as when the male to female threaded plug was changed the plastic fuel pump housing cracked and rendered the motorcycle inoperable until a replacement fuel pump can be shipped from germany.this transfers the fuel under pressure to the efi and when turned on with the crack sprays/leaks fuel over the side of the motorcycle onto the hot exhaust. The motorcycle was trailered to the dealer where the part was ordered from germany with a two week wait at the price of $475.00 plus s&h and installation charges yet to be determined.
1) smelled fuel while riding, saw fuel leaking onto hot motor, stopped immediately.2) a plastic quick-disconnect coupler had cracked allowing fuel at high pressure to spray onto hot motorcycle engine. Air cooled motor,extreme fire risk. 3) bmw part # is 13537674765, made by colder products company. Part is plastic, becomes brittle and cracks or breaks off on the male side of connector.there are two lines (feed & return) second plastic coupler broke off during disassembly. Cpc also makes the exact same quick- coupler in chrome plated brass, i replaced both plastic connectors with metal ones.total cost of repair was less than $100 including new clamps & o-rings.i have the old parts, but this is a common problem, known to bmw and many have failed. All bmw r1200rt, r1200st, r1200gs models have these fuel line quick-disconnects sitting on top of the motor connecting the fuel tank. They should be recalled before someone burns to death on their bike.
Throttle cable bell cranks crack due to poor quality plastic material. This causes motorcycle to suddenly lose power as hand throttle no longer works, and engine returns to idle speed. This can lead to a serious safety hazard if this occurs on high speed roadways, freeway etc. My vehicle was being serviced when the cracks (and impending failure) were noticed by service personnel.
Interference fit wheel adapter on final drive axle tube lost it's proper fit causing the rear wheel to develop a wobble greater than 1 mm (3 mm) at 15,750 miles and 18 months of use. Wheel created a handling problem.a new splined adapter was interference fit to the existing axle tube spline on the final drive.
Bmw 2005 r1200st final drive failure.
Throttle cable bell cranks crack due to poor quality plastic material. This causes motorcycle to suddenly lose power as hand throttle no longer works, and engine returns to idle speed. This can lead to a serious safety hazard if this occurs on high speed roadways, freeway etc. My vehicle was being serviced when the cracks (and impending failure) were noticed by service personnel.
Read more
