Enter VIN number
Get the most accurate report for the vehicle. Basic information is FREE
Use this form now and GET 20% DISCOUNT for CarVertical reports!




We found the following complaints for BMW BMW MOTORCYCLE (1999)

Read complaints for BMW BMW MOTORCYCLE (1999)


The final drive failed due to the large crown gear ballbearing breaking apart leaving me on the roadside,this happens to alot of bmw k 1200 lt motorcycles owners as bmw used inferior components and poor designing methods for this heavy 860 pound motorcycle,it uses the same type of final that is used for the lighter motorcycles on this heavier one.

Rear drive of motorcycle has failed at 31k miles

Possible design flaw of motorcycle experinced failure on two occasions to gear lever which was caused by a small stone that bounced up on top of a flat portion of the exhaust system located under the engine clutch lever arm and wedged between the engine clutch arm and exhaust preventing the clutch arm from returning to the engaged position resulting in failure.

Severe vibration, noise and loss of control due to rear end drive failure.

Rear drive failure on bmw k1200 lt.motorcycle started vibrating and rear end started wobbling.

Failure of final driveon bmw motorcycle.bike had 50,000 miles.cost $2,000 to repair, not covered!

Bearings in the final drive failed, resulting in a loss of lubrication and an unstable rear tire preventing further safe travel.

Rear drive bearing failure, second one in 13,000 miles.rear drive was noticably loud.harmonic growling noise.i dissasembled it and the large ball bearing is pitted.this time i caught it before catastophic failure.i purchased a used rear drive and will rebuild my old one so i can carry a spare.(pretty sad when a bmw pilot has to carry a spare rear drive).

I had two bearing failures in the final drive of my bmw k1200lt motorcycle. Both of these bearing failures could have led to a rupture of the seal which would have let the final drive lube flow out of the final drive onto the rear brake and rear tire which would have made the rear tire loose traction and the rear brake inoperative.these failures caused a complete final drive rebuild and replacement of all bearings and seals in the final drive at a cost exceeding $800.00 each.

Rear drive failure ona a bmw motorcycle.

Transmission shift linkage failed.

Final drive on a 1999 bmw (not listed for motorcycles) k1200lt failed with under 45,000 miles.

The contact owns a 1999 bmw k1200lti.the rear wheel separated from the motorcycle while driving between 20-25 mph. Consequently he and the passenger were ejected from the motorcycle . Both occupants sustained injuries. The insurance company notified the manufacturer of the failure.the vehicle was completely destroyed. The current and failure mileages were approximately 18,600.




Read more




© 2025 All rights reserved