We found the following complaints for BMW 325IS (1994)
Read complaints for BMW 325IS (1994)
When the vehicleis started, airbag light comes on and will not go off. Dealer has not seen vehicle.
The airbag warning light comes on every time the vehicle is started. Dealer has not seen vehicle.
Aftertaking vehicle through a carwash engine hydrolocked and caused fuel to inject intoengine.dealer said engine has to be replaced.consumer states dme shorted out causing it to hydrolock and causing engine and fuel components to be damaged internally.
I am told that this is an ongoing problem for 3 series bmws where the water backs up under the windshield and it gets into the electronic computer and shorts it out.
Aftertaking vehicle through a carwash engine hydrolocked and caused fuel to inject intoengine.dealer said engine has to be replaced.consumer states dme shorted out causing it to hydrolock and causing engine and fuel components to be damaged internally.
Ltr re a defective hood latch on a 1994 bmw 325is, requesting a defect investigation.while driving, the hood latch disengaged and cause the hood to open.
Owner of a 1994 325is.was driving on highway and transmission suddenly died down (slipped out of gear) almost causing the vehicles behind to almost crash into me.in illinois.called the national bmw customer center and they say they have no active recall despite numerous complaint of incidents with the transmission of 325 i in the consumer reports site.this vehicle has been well kept and maintainedplease look into this, someone can get killed.
The 1994 bmw 3 series has a clutch lining problem that will cause the car to buck and throw itself forward when stuck in stop and go traffic for any amount of time.although this is called a minor incomvenience by bmw, it can cause a low impact accident if the clutch and dual mass fly wheel are not replaced.... $2000 later.
Outside door handles on both doors became inoperablewithin a month of each other also trunk latch broke dueto the way it is attatched to trunk lid ie two screws thru sheet metal, sheet metal broke around both screws
I am a member of the bmwcca and a bmw automtive enthusiast.i have notice for many years the occurannce of a common failure in e36 and e46 body styles - for all years of production.the rear subframe is attached at four mounting locations to the unibody.the unibody is not reinforced at the attachment points.failures have occured where the unibody sheet metal cracks and in many cases the rear subframe is ripped from the car.in germany, bmw has recognized this problem and has issued a recall to reinforce the subframe attachment points.i feel it is time that bmw takes ownership of this problem in the usa.please help.this problem will worsen as these cars age and will eventaully cause fatalities.please contact mefor more details - i can provide numerous photos form club members.thank you in advance.[xxx]information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6).
While drivingengine overheated.vehicle had to be towedto dealer, and technician told consumer that was caused by the heating core.
Read more
