We found the following complaints for DORMAN STEERING SHAFT (Unknown)
Read complaints for DORMAN STEERING SHAFT (Unknown)
Dorman steering shaft425-158 play in steering shaft pins came lose.
2013- april, rubbing noise coming from steering column for a few months then steering became too hard, barely made to dealership.steering gear assembly replaced along with intermediate steering shaft part no. 25979679 at 38,643 miles.2019-december rubbing noise again and slight shifting of car to left pulling into parking spot, lower u joint on intermediate steering shaft with too much play leads to steering shaft being installed part no. 25979679 installed at 72,712 miles.2020-february rubbing noise starting again car will be checked out on april 18th.this car has had no hard use such as commuting or multiple long distance driving.*dt
A recall notice was released by dorman products for a faulty steering shaft on october 16 and my company was not notified by mail until a postmark date of december 12, 2008.
The contact owns a 2001 chevrolet silverado 1500 equipped with a dorman exterior door handle.while opening the rear drivers side door the contact's hand was cut on the door handle as it detached from the vehicle.the vehicle was not taken to the dealer to diagnose or repair the door handle. The failure and current mileages were 90,000.the vin was unavailable.
I have a 2005 chevy 2500 i have had the steering shaft replaced 2 times already and now at 80,000 miles it has gone out again. I have contacted gm about this problem, they are aware of the problem but unwilling to do anything about it, they say its not a safety issue. Well maybe they should drive it for a day they would think otherwise. It feels like the steering wheel shaft and all is about to fall out of the truck , i am afraid to even have my family ride it the vehicle with me. I have researched online and this has been a ongoing problem for some time and gm has not addressed the problem. I would advise whom ever to get online and research all of the blogs etc of people having same problem their are so many it would take me months to read them all. I spoke will gm again last week and they told me to contact your office and report it to you if i want this problem resolved. I believe it is a safety issue and should be recalled. If the steering shaft vibrates long enough it will break and then no steering. Thank you for looking into this issue and helping me and the millions of other people experiencing the same problem. Again this will be the third time this part has been replaced first at 20,000 then 42,000 and now at 78,000.
I have a 2005 chevy 2500 i have had the steering shaft replaced 2 times already and now at 80,000 miles it has gone out again. I have contacted gm about this problem, they are aware of the problem but unwilling to do anything about it, they say its not a safety issue. Well maybe they should drive it for a day they would think otherwise. It feels like the steering wheel shaft and all is about to fall out of the truck , i am afraid to even have my family ride it the vehicle with me. I have researched online and this has been a ongoing problem for some time and gm has not addressed the problem. I would advise whom ever to get online and research all of the blogs etc of people having same problem their are so many it would take me months to read them all. I spoke will gm again last week and they told me to contact your office and report it to you if i want this problem resolved. I believe it is a safety issue and should be recalled. If the steering shaft vibrates long enough it will break and then no steering. Thank you for looking into this issue and helping me and the millions of other people experiencing the same problem. Again this will be the third time this part has been replaced first at 20,000 then 42,000 and now at 78,000.
A recall notice was released by dorman products for a faulty steering shaft on october 16 and my company was not notified by mail until a postmark date of december 12, 2008.
2013- april, rubbing noise coming from steering column for a few months then steering became too hard, barely made to dealership.steering gear assembly replaced along with intermediate steering shaft part no. 25979679 at 38,643 miles.2019-december rubbing noise again and slight shifting of car to left pulling into parking spot, lower u joint on intermediate steering shaft with too much play leads to steering shaft being installed part no. 25979679 installed at 72,712 miles.2020-february rubbing noise starting again car will be checked out on april 18th.this car has had no hard use such as commuting or multiple long distance driving.*dt
The contact owns a 2001 chevrolet silverado 1500 equipped with a dorman exterior door handle.while opening the rear drivers side door the contact's hand was cut on the door handle as it detached from the vehicle.the vehicle was not taken to the dealer to diagnose or repair the door handle. The failure and current mileages were 90,000.the vin was unavailable.
Read more
