We found the following complaints for COSCO 02-034 (Unknown)
Read complaints for COSCO 02-034 (Unknown)
The contact owns a cosco summit deluxe high back booster, model number 22-260hou (na). The contact stated that he has two safety seats.the second seat is an eddie bauer 22-755mac and is being recalled.the contact stated that both seats were identical and are experiencing the same failure with the harness adjustment strap.the cosco seat is not recalled.there had been no failure to date.updated 03/12/08
Cpsc: i1330396a. Cosco scenera. Consumer stated while rear facing the child head bobs up and down, and can cause serious injuries. *ln
Dt*: the contact stated where the strap feeds into the back of the child safety seat, the strap pulled loose.the seat was a cosco, eddie bauer.model #22-625 glc.manufacturedon04-21-04.
I received a brand new seat with no lower anchor strap.the seat is:cosco mighty fit 65date of manufacture 06/15/2017model number cc177-egb, purchased from walmart
Dt*:the contact stated the shield assembly was broken.the pull down bar that connected to the car seat fractured.also, a spring disconnected resulting in visible and tangible sharp edges.the car seat manufacturer was alerted and offered a replacement car seat.cosco, model# 02-537-ebk, dom- 09/07/2001.
The contact owns a cosco barnyard buddy sprinter travel system (n/a). The contact stated that the shoulder strap did not secure the child into the safety seat. The child was able to pull the strap from the secure position. The contact did not notify the manufacturer.(related vehicle information: model year=2001, make=lesabre, model=buick)
Dt*:the contact stated the four screws that hold the adjustment bar located on the back of the child safety seat have loosened over time resulting in complete detachment of the adjustment bar.the adjustment bar is used to adjust the height of the shoulder straps and without the screws the straps can no longer be adjusted.the adjustment bar could probably be screwed back into place however, the contact expressed hesitation due to safety concerns.the manufacturer was alerted who provided no reassurance for continually use of the safety seat.the seat was only in use for three years and has never been in an accident.the manufacturer of the child safety seat is dorel juvenile group.the brand name is cosco.the model # is: 22-260 hou.
This is a general complaint and inquiry about car rental companies and infant car seats they provide as well as installation.i have had 3 experiences from 3 different car rental companies where the equipment provided was not complete and i either had to complain until i received the proper equipment or personally purchase my own.one of the cars was a 2003 model which i thought would have the latch system (isn't this required?) but didn't.also, even though i was told when making reservations in all 3 instances that there would be someone who knew how to install the car seat properly, assistance was not provided or the employee admitted they didn't know anything about car seat installation while trying to help.i have heard from other parents that my expereinces are not uncommon.my question is, what responsibility do car rental agencies have regarding car seats, possible recalls, and providing all the equipment for proper/safe installation of car seats they provide?are they required to update this equipment or inspect it to see if it is in working order?if necessary i can provide specifics for 2 of these occurances as i received a partial refund after complaining to the company and i can ask others i've talked to to also provide details of their experiences.please let me know if there is another agency i should contact.
Consumer statescosco eddie bauer child seat is broken. Hinges are broken on either side on the part of the seat that comes over the child's chest.no one has been playing with them.consumer does not know the model number.
Dt: the consumerowns cosco summit model # 22-260-hou, dom 08/06/2003. Her child caughtfingers in a hole in the frame of the car seat. The child's finger was caught and she could not remove it. The child was taken to the emergency room to have her finger removed from the hole.the child's finger was injured worse trying to get the finger out of the hole in the seat. The holes are on both sides of the seat and are covered with fabric. The owner has not contacted cosco at this time.
My 2 year old daughter can easily unbuckle her eddie bauer car seat/booster seat's safety harness. This is the top buckle, that goes across her chest. My friend's son, who is 1 and uses the same kind of car seat, can unbuckle his also. This is a serious design flaw. If a child unbuckles the safety belt and a parent has an accident the results could be fatal. Additionally, sometimes the seatbelt buckle seems like it is snapped even when it isn't. There is no locking mechanism or sound or other cue to indicate that the buckle is actually secure. Simply snapping it together does not necessarily mean it is secure.i bought this car seat thinking we could use it to the maximum weight limit, which is 80 lbs. Though our children weigh less than 30 lbs.
Dt:consumers child was able to unbuckle the child seat and she was only two years old.sheunbuckledthe top straps of the child seat.the information that the consumer has found on the child seat was registration43594502, cosco model numbers.f12482 lot no. 1421514316-1490. She could not find any other information on the child seat.date of purchase was unknown, but manufacturingdate was 02-22-03.
Dt: cosco juvenile model number 22-260-bsc, dom 12-21-2004.the child, who is 17 months old,is able to unbuckle the seat by himself. While drivingthe child had unbuckle himself by pressing the button to unlatch the seat.this happened more than once.the first time this occurred was about two to three weeks ago.the most recent time was on 8-26-05.there have been no accidents as of yet.
Dt:the contact owns a convertible coscoeddie bauer model # 02-537 car sear.when the child weighed over 40 lbs they converted it to a booster. The positioner for the straps were not big enough for the straps to go through,they would jam. The shoulder strap at an angle would not fit. The strap would not recede into the mechanism when the child leaned forward. The straps would jam. He calledcosco and they sent a replacement positioner.updated 1/11/2006.the replacement positioner is performingas it should.updated 10/31/2006 -
Dt: cosco model #92880-ebn, consumerhad the child safety seat for approximately two weeks andstraps didnot stay connected to the back, and theywill buckle.the childseat initially worked well.it was purchased new.the seat was taken to the ems, and they advised her to call and make a complaint.
Dt:cosco car seat/stroller model gb4359-5446, dom 02/08/2004. Contact stated the carrier part of the car seat/stroller has a seat belt part and the back latches will not stay locked. It can just be sitting there and come unlocked. This happened inmay 2005. She was not using it lately because she did not know what was wrong with it.contacthas not taken it back to walk-mart where she bought it.
Dt:cosco doral juvenile group model #22-002-daz gb.it can be connected to a stroller.the harness latch stuck in august o 2005.the consumer has been unable to detach the harness.the consumer is concerned that the latch is unstable.
The contact owns a cosco 02-034 child restraint (model number 22-120 wal).the contact stated that her one year old is able to unlatch the plastic chest buckle on the child restraint.the manufactured date was march 2, 2006.the manufacturer has not been contacted.
Dt:cosco model # 02-019 wal, dom 01/01/2000. This car seat broke around august 30, 2005, the bar that comes down over the child broke, and the springs on the left hand sideand the right hand side split.onecan see the springs,they completely came apart from the child safety seat.
Dt: the contact owns a cosco model22300swb, domoct 6 2004 car seat.the harness broke at the top. There was a recall on some car seats, but thismodelwas not included in the recall.
The contact owns a cosco child seat, model # 22 565 wal, production date 01/24/2006. The contact was involved in a frontal vehicle crash. Upon further inspection of the seat after the crash, she noticed that the harness buckle fractured then separated from the safety seat. As a result the child suffered bruises on her shoulders. The manufacturer has not been notified. She has possession of the safety seat.
The contact owns a cosco summit deluxe high back booster, model number 22-260hou (na). The contact stated that he has two safety seats.the second seat is an eddie bauer 22-755mac and is being recalled.the contact stated that both seats were identical and are experiencing the same failure with the harness adjustment strap.the cosco seat is not recalled.there had been no failure to date.updated 03/12/08
Dt:the contact was having problems with coscomodel # 22-145-wal child seat.it wasdifficult to pull the harness straps over the child's head. When attempting to pull the harness strap down it sprangback. On several occasions the harness buckle struck the child on the head. On one occasion, there wasa bruise onchild's head.on last occasion, she was forced to free her child by cutting the straps because there was not enough slack in the harness strap to remove it. A phone message has been left with the manufacturer three times.
Dt*:the contact stated the four screws that hold the adjustment bar located on the back of the child safety seat have loosened over time resulting in complete detachment of the adjustment bar.the adjustment bar is used to adjust the height of the shoulder straps and without the screws the straps can no longer be adjusted.the adjustment bar could probably be screwed back into place however, the contact expressed hesitation due to safety concerns.the manufacturer was alerted who provided no reassurance for continually use of the safety seat.the seat was only in use for three years and has never been in an accident.the manufacturer of the child safety seat is dorel juvenile group.the brand name is cosco.the model # is: 22-260 hou.
Dt: cosco model #92880-ebn, consumerhad the child safety seat for approximately two weeks andstraps didnot stay connected to the back, and theywill buckle.the childseat initially worked well.it was purchased new.the seat was taken to the ems, and they advised her to call and make a complaint.
Dt*: the contact stated where the strap feeds into the back of the child safety seat, the strap pulled loose.the seat was a cosco, eddie bauer.model #22-625 glc.manufacturedon04-21-04.
Child seat latch failed, and the tether popped out.the infant was notsecure in the seat. Model 22-009-fsm
The child safety seat had no padding where the child rested his lower back which caused bruising.
Dt:cosco model # 22-260-hou, dom 02/13/2003. The shell that the child back leaned up againstbroke, the hole where the harness goes through busted.
Dt*:the contact stated the shield assembly was broken.the pull down bar that connected to the car seat fractured.also, a spring disconnected resulting in visible and tangible sharp edges.the car seat manufacturer was alerted and offered a replacement car seat.cosco, model# 02-537-ebk, dom- 09/07/2001.
Child seat latch failed, and the tether popped out.the infant was notsecure in the seat. Model 22-009-fsm
The contact owns a cosco 22-208 model child safety seat.the child seat tether strap elastic cover strap was not included when purchased.the the owners manual indicated that the part should have been included.the contact called the manufacturer and was unsuccessful.the model number is not listed in the drop down menu.
We bought a problematic cosco car seat from target, over a year ago.the model number is not on your list of cosco car seats.model # 22206-gth, manufactured on 04/05/2007.like all modern child car seats, the cosco car seat is secured by two latch clips, down behind the bottom of the seat, and also by a tether strap at the top.the tether strap goes over the top of the automobile's seat and then down the back of the seat to a recessed tether point low on the back of the seat.***>>>that tether strap is the problem***<<<. The cosco car seat does not have the proper adjuster on the tether strap.the standard adjuster was replaced with a difficult buckle, with no moving parts.in this degraded design, which saves the manufacturer a few pennies, the tether strap cannot be tightened after it is hooked onto the anchor point. Tugging on the strap does nothing. The user can, with difficulty, change the length of the tether strap before hooking it onto the anchor point. By this means the user may slowly and clumsily get the tether strap about the correct length, if she or he has the time and knowledge to make the complex adjustment. But even a skilled user, with plenty of time, cannot tighten the strap, because the adjuster is missing. The best a person can do is get the tether about the right length, providing some stability for the child car seat, and then hope that is good enough. I feel that this car seat will be unsafe for all but the most careful and experienced user. I have been a licensed child care provider since 1975.(related vehicle information: model year=2003, make=honda, model=pilot)tw*
The contact owns a cosco 22-208 model child safety seat.the child seat tether strap elastic cover strap was not included when purchased.the the owners manual indicated that the part should have been included.the contact called the manufacturer and was unsuccessful.the model number is not listed in the drop down menu.
Consumer statescosco eddie bauer child seat is broken. Hinges are broken on either side on the part of the seat that comes over the child's chest.no one has been playing with them.consumer does not know the model number.
Read more
